Search results for query: *

You guys should definitely go through my thread on how I did my Hemi swap .. I put a lot of little notes in stuff I ran into doing this .. 6.1 Hemi Swap Hope it helps you guys !

I did check that and it’s pretty close .. My fan controller is set at 192 and has no problem cooling it down or coming on and off as needed

I drilled and tapped the thermostat housing and put my probe in there.. Also used the same area for my fan control. It worked out great

I wanted to give my review of the TTi header for my Gen 3 hemi swap Challenger with Borgeson Box that i did over the weekend .. I wanted to say this isn’t for the faint of heart at all ..As i love the quality of the header , getting to tighten down the 8 bolts per header was an absolute pain...

I have done this swap with the 6.1 .. It as said makes 425 stock with much better internals rods , pistons etc no Mds .. I do run the 545rfe with an 2008 Ram 1500 computer and Hotwire harness. With the 3.91 gear , it does a nice cruise plus i can get into it a bit without a problem , very fun...

I replaced the guides , stops and plastic related pieces. Also adjusted the door / fender still notta

I got my new glass in with hardware and my passenger is perfect goes up and down no issues , super smooth with gaps all correct however , my driver side is maxed out pushing the top glass out and still hits the rubber . Not sure what is going on here but maybe one you guys can explain

Yeah It needs to go on the rack so we can get it dialed

No it’s been a while since I’ve aligned it , Means with the car off not running I’m able to move the tires side to side meaning the play from the fluid not moving through the Steering box. With the car at idle , there isn’t any play in any of these parts .. I also said back in my original post...

It’s got about 8,000 ,miles or less on that stuff

They are qa1 arms upper and lower tubular k member pst torsion bars and magnum force 2” drop spindles

Running a 255/40/18 up front , all the stuff is pretty new (from dr diff) hubs, bearings and seals. There is no play in that stuff

Ok Ive been having some inner tire wear on my 73 challenger and it’s starting to wonder a little bit so I decided I decided to take a look under It .When I Got it up in the air,checked everything related to steering and didn’t see anything at all that was loose or had any play in it. With the...

If you guys want look in this section , I posted how I did my swap . Only thing I changed is to an 08 ecu (for tuning purposes) but it’s been a champ so far

Im using the 545rfe trans so this one computer controls it

Angles are off it has a 6.1 hemi 545rfe and it needs the pinion set agian

Looking to eliminate vibration….

Ok need a quick recap i measured my driveline angels today and got these measurements .. Now i’m pretty sure i need a 2 degree shim in the rear to make my operating angles pretty good .. Is this correct or iam i missing something here .. ? Thanks guys!

I did yes my Ac lines come through where the ecu is on top of it .. Tight fit but it works