Search results for query: *

I was changing universal joints and noticed that the slip yoke was on the bigger end of the drive shaft instead of the tapered end like i am used to seeing.. Just so happen was watching graveyard cars and noticed a barracuda.With the drive shaft the same way, the slip yoke was on the bigger end...

While installing the rear valance, I realized that There are no trunk extensions installed.. It had new quarters, and trunk floor that was already installed when I got the car.. As I was looking at pictures on the web , I noticed that about three out of every five pictures do not have trunks ...

I recently bought a mounting kit for the rear valance. It has 4 nuts 4 studs, 2 smaller hex bolts and two smaller phillips head bolts.. I know where the four studs and nuts go.. Best I can figure is the two smaller phillips head screws go in the center supports and the two smaller hex bolts go...

I am slowly putting this seventy three back together, working on the rear shocks.. There were no shocks on the car when I got it.. This is what I found in the upper cross member where the shocks go with a bolt going through in a nut.On the other side.. Not.l, Sure what it is unless it is part of...

In this picture, where does the spring go?Thanks.

Passenger side brake line goes under the frame.My question is , does it go behind the gas lines or in front of the gas line.. Also, driver side brake line comes under the frame and comes up to the proportioning valve.Does it go in front of the master cylinder lines or behind them?Thanks

Does anyone know if the factory fuel filler tube rubber gasket that goes through the trunk floor, had a thin metal ring around it... That went over the gasket, and the screws went down through the metal ring and through the rubber gasket into the floor of the trunk. Thanks

How tight should the gas tank straps be on a 73 barracuda ..thanks

Running the brake line on the driver's side.How does it go through the cross member pics would be a help , also , is there a diagram where the brake line clips or brackets are located thanks

Where the replacement quarter panel meets the roof.. The factory used lead it looked like... What is everyone doing to address this.. Going back with lead or something else.. Thanks

Looking for a 73 barracuda , radiator overflow bottle and bracket...thanks

Looking for a good set of cuda 340 hood emblems...thanks

Looking for a diagram that shows\nThe rubber hoses from the gas tank to the separator.\nFor any other diagrams for the routing to the canister.. Thanks

Plastic taillight, assemblys are they side specific? If so, how do you tell the only thing I notice that there is small plastic tab that sticks out on each one of them.. i know the backup lights, go in the center and the brake lights and taillight.Go to the outside... Just didn't know if they...

73 barracuda cowl piece needed... I am in need of the curved piece in the pic.. That has the blue outline.that goes above the windshield wiper motor it looks to be a separate piece.it has the additional slots for the cowl seal and hangs, Over the wiper motor.. I need to know if it is available...

Who sells the replacement taillight , mounting studs for a seventy three barracuda thanks

When you don't have the old spark plug wires on a engine..to use as a replacement guide, What is the best way to know? Which length of wire goes Where.. I know the firing order and will be using the factory wiring clips on the valve cover.. Just curious if there was a specific way to do it...

It has a lead wire of about Five or six inches that goes to the choke.. Does it seem like it would be too far away.

Can someone ID these 2 pieces?\nThanks

Looking for the factory , acorn style nuts that hold the taillights to the back tail panel for a 73 barracuda... I believe there are 16 of them thanks