-
Continuous 12V power signal while cranking for Holley Sniper EFI
Yes, the balast resistor is the best spot.- romi
- Post #3
- Forum: Electrical and Ignition
-
Fitech EFI setup
Also, where's your IAC steps ranging after the engine is warm?- romi
- Post #7
- Forum: Fuel and Air Systems
-
-
Fitech EFI setup
Agree with rklein71. I just finished my Fitech install. need good clean minimum 10v to the white wire. Good way to check is to connect direct to the battery (through a fuse just to be safe). If it starts a lot better then you know your old connection is an issue. Also are you getting any fault...- romi
- Post #5
- Forum: Fuel and Air Systems
-
Classic Car Insurance
Changed last year from Haggerty to Grundy. Saved $80. Quite happy.- romi
- Post #16
- Forum: Mopar General Discussions
-
FOR SALE 1971 cuda parts for sale
Hey dogbone, do you still have that door latch?- romi
- Post #12
- Forum: Cuda - Challenger Parts for Sale
