Search results for query: *

It's very possible, but I did make my own brackets by modifying the factory bracket to fit the Sanden compressor. jess in ky 440/6, Sanden a/c compressor, how I did it....

You're correct, final scenes in the movie, it was very obvious. I doubt any of the cars used in the film were viewed as valuable after they were through with them, it was 1970, they, and many others like them were everywhere. As special as they are now, seems impossible that they were "just a...

Anyone have a couple of pics that illustrate the difference in early and late hinge covers? jess

I can't say if there IS a difference or not. But I put a rallye cluster in my non rallye dash frame. Fit and function fine. 70 challenger

In my humble opinion, it will be fine. These cars weren't built to within 1/4 inch in a lot of places. my .02 only. jt

Summit has these: Holley 108-1 Holley Fuel Bowl Inlet Fitting Gaskets | Summit Racing and Grainger has these: https://www.grainger.com/product/PARKER-Flare-Gasket-For-5-16-in-Tube-5WRW2?searchQuery=5wrw2&searchBar=true&tier=Not+Applicable 3 of the gaskets and a about 10 or12 of the flare nut...

Yes sir. jess

Neither actually, car was dipped in grey primer up to about the door handles. All the paint the underside received was overspray from painting the sides, rockers, etc. Some did receive optional undercoating, probably the black stuff you are seeing under your Satellite. Some restorers go to great...

I have a set for sale, though they are dated a little early to be "date code correct" for an E body. PM me for more info. jess in ky

Pull both tires and measure the length (both sides, from bushing to ball joint) of each upper control arm. Inspect the mounting points of each upper control arm, compare from side to side. These cars are 50 years old, lots can happen. jt

Hello SCHU: I searched through the restoration pics of my car and these are the best I could find of what you are searching for, hope they are of some help to you. In the first pic you can see the bottom of the "dual exhaust" dr side hanger at the very top of the pic. The "welded on" hanger on...

70 Challenger, Dana 60, Factory rear sway bar

It's my understanding no Dana equipped E body got a rear sway bar. (They will fit and clear everything though). jt

You're right about the seat belt bracket (I believe it would be prudent and take up some space to add to the thickness of the SB mount), then maybe you could heat and bend the wheelwell over to mate up?? Judging from the shot of my (original) wheelwell/floorpan, it appears they left the...

Would these be correct for your car? 2863553 date code 09148, 2863549 date code 08278,

My money is on a late 70's F body.:confused:

:popcorn::thumbsup:

I have a stock E body rear sway bar on my 70 challenger with Dr. Diff's offset rear hangers and a B body Dana 60. I have Accurate LTD's 2.5 inch exhaust system. It is configured as stock and fit easily around everything. There's no need to heat the bar, just put it in a press and bend it. (...

"noisier than stock A833 gears" I've been running one for a few years now and this is the ONLY complaint I have. All gears that work through the countershaft (not just reverse) are noisier than the 18 spline I replaced with it (don't have near the mileage on it either though (still breaking...

Looks like a Cuda rear side marker retainer??