Search results for query: *

Hi, looking for T/A steering box and related parts. Thanks

Since this is turning to a info thread. I have an AAR Cuda. Manual box, I am converting to power steering. I was interested in the factory TA box for originality.

Looking for a TA steering box. Thanks

Thanks

How do you remove the cable at the torsion bar cross member. Where it passes through.

Thanks that is informative. Thanks for that vid.

Has anyone found a source for Organisol recently.

Ok Thanks

I have to replace my original hood as it has had so much damage over the years. Looking for the best original look and quality.

I think I will stick to my plan. And just drive it that's why I bought it.

I have an AAR Cuda I bought a few years ago. Its a nice driver not numbers matching missing the original 727 and engine. I didn't care because I wanted a driver it looks great but not perfect. I am now putting a 410 stroker in. My question is prices are going up so I am watching that and I am...

Does anyone know if the 17x9 wheel will work on the front of a 70 Cuda I want to run a square set up.

Well I originally had the hose correct and couldn't get the outboards to open switching the hose to the upper curved port on the metering block and then the outboards work.

Ok I went out and pulled the vac hose and checked for vac engine running. I have had the hose installed on the lower vac port and there is no vac signal not even ported vac. The upper port had straight vac when I attached the hose there was a vac squeal very light amost hard to hear. This...

I would post but having trouble uploading. I think I will give that gopro a workout. great ideas Thanks.

Is there anyway to pull vac engine off to see the sec carbs open.

Timing, ign is good vac lines are good engine runs good idles perfect but I haven't checked fuel pressure just a cheap old airtek style pump.

Ive gone by the service manual and checked for binding and adjustment. I can check again.

I have a 340 Six pack and I cant feel anything or tell if all three carbs open It just feels flat no pull. I checked everything linkage carb opening full throttle just don't see anything It feels like a two barrel. The weired thing is I have a spare set of carbs and they do the same thing so Im...

Great thread and you've got a great car. I have been pondering this same type of swap but Im going from an auto In an AAR Cuda . The car is not numbers and once had a manual trans when it was raced now a street car. I like the use of the shorty TTis I have regular ones and would also like to use...