Search results for query: *

Hello, I'm looking for a "reasonably priced" 1970-71 Unsilenced 340 air cleaner. It doesn't have to be refinished but if it is, and done correctly ie, wrinkle finish isn't put on super heavy and cracking I would be interested in it as well. The two biggest factors are condition and price, which...

Price Reduced!! For Sale is a very nice, recently blasted and painted bell housing. All the threads are re-tapped and/or cleaned and are in great shape. There are no chips or cracks in the housing. The part number is 2892482 it was cast in 1969. This bell housing was typically used on 1969 and...

Price Reduced!! For Sale is a very nice, recently blasted and painted bell housing. All the threads are re-tapped and/or cleaned and are in great shape. There are no chips or cracks in the housing. The part number is 2892482 it was cast in 1969. This bell housing was typically used on 1969 and...

I was unable to find a reproduction emblem made specifically for the 71 Challenger tail light panel. So I purchased a 3 pin emblem for the 70 Challenger front fender and re-drilled the center hole location on the tail light panel and it Worked out fine. The original center pin hole is covered by...

New unused mounting plates for cuda or challenger. $20.00 plus shipping.

Good used, 3.54 Dana 60 gear set with yoke. Nice run pattern on gears. $110.00 obo, plus shipping.

For sale is a set of front and rear bumper guards for a 70-71 Challenger. They are complete but in need of new rubber strips (which are now reproduced) and rechroming. $300.00 for the set plus shipping. These are photos

For sale is a very nice, freshly cleaned, blasted and primed transmission cross member. It has the correct mounting bolts included. No need to buy junk and spend hours scraping off old grease and dirt and then have someone sand blast it to make it look good. This one is ready for you to paint...

I started this project in September of 2015. This is been a full rotisserie restoration. It is now painted in Curious yellow and has the vinyl roof installed. It is an original 383 4 Barrel 4 speed car which is now going to have a stroked 383 (437), with a Hemi overdrive 4-speed and a b-body...

The intake is in great shape, Had it baked and shot blasted. The bottom plate was removed, prior to cleaning and properly reinstalled. All the threads are in great shape. The pictures are of it after cleaning. I have since painted it in primer to prevent any rust issues starting. I'm asking...

71 CUDA Inner Fender Splash Shields. I have a pair of inner fender, headlamp splash shields for sale. They are new and have not been mounted. There is a small chip on the down leg portion which shouldn't affect it at all. New BEA sells them for 135.00 Year One is 155.00 I'm asking $55.00 plus...