Search results for query: *

Hey Howdy, John, was hoping you got my emails and PMs here. Let me know if you got my shipping address thanks. Not sure if these PMs and whatnot are getting through.

Thank YOU! I should've checked there first.

I'm looking for the gasket that goes on this piece? IF not, what material could I use as a substitute? thanks

A pair of front bumper end fillers pieces, off of a 73 challenger. No cracks, missing a few studs/screws, these will clean up nice. asking 65. Plus shipping, PM if interested.

This came off a 73 challenger, which had a Tuff wheel, with this steering column adapter. No pry marks, light rust, splines look good. I'm told they're kinda rare and the B body folks also use them. asking 250. plus shipping. PM if interested.

got your email with pics. I’ll Definitely take those two items. Thanks

Interested in the tail light lenses. PM sent thx.

I got it figured out today. The 5/8-18 nut threaded tight for the first 2/3rds of the thread, then went on like normal. I had to hold the rear ring portion of the pivot shaft with a vice grip. No problems. thanks everyone for the advice.

Yeah they pressed in easier than I thought. I called PST tech support today, guy said he gets a million calls about this all the time. He advised me to use a prybar and a socket in the back where the torsion bar head goes in and then I should be able to thread. But I still wont use that 3...

So... finally getting around to installing the LCA on my 73 chally, went with the PST lower control arm shafts. The problem is, when I try to tighten the nut, the shaft spins. I definitely dont like the nut with the three dimples. I understand the reasoning, but does anyone know the thread size...

So, I've finally gotten into the rear end of my 73 challenger. 489 case, and 2.76 gears, with a non Sure Grip ( go figure?) I'm going to be giving Dr Diff some of my loot for Sure grip unit and was thinking about gear too. mild built 440 with a A518 transmission. My goal is to get on the...

Awesome, you Rock !! thanks

I need a patch panel for the front section lower of a RH side quarter panel. Anybody ? Sherman AMD Goodmark doesnt matter, hell, PM me if you have an old quarter panel cut up. Appreciate it.

Yes mine are missing, I just need the straps. I have fancy bushings and bolts already, figured I'd fab some side straps and needed to know the distance between the bolts.

Can someone share the dimensions of rear leaf spring shackles for 73 challenger. specifically the Distance between the bolts on the shackle straps. also the width please, thank you.

Thanks floyd, I'd a never guessed that !

Stupid question... what is this? nothing was attached to it, and I can't figure out what it is for. Thanks

So i recently began restoring my 73 challenger, and in removing the interior, headliner, I found a bunch of old socks wadded up and stuck in there. Both sides actually. I remember wearing socks like these back in the day. early 70s. they feel heavier than the ones nowadays. Why in the hell...

I got it, had to press in the sleeve first, then the poly bushing, then the shaft. BTW i did weld the stiffening plates, Thx Adam.

Has anyone here used the PST Polygraphite bushings with sleeves and new PST Pivot shafts? I'm having trouble installing them in my lower control arms . I tried several ways, first pushing the bushing into the sleeve, then the pivot shaft, but then how to install in the LCA, without smooshing...