Latest activity
-
Communication was great. The buckles were in decent shape...I don't recall if they were rechromed or just polished. -
CCuda_mark replied to the thread Seat belt restoration.Communication was great. The buckles were in decent shape...I don't recall if they were rechromed or just polished.
-
Lunchbox replied to the thread Seat belt restoration.Communication good? Did they re-chrome or did you have pretty nice buckles already?
-
Lunchbox replied to the thread Steering Shaft Moves In and Out.If you are converting from manual to PS you will either have to collapse the telescoping shaft to make it shorter or find a PS...
-
CCuda_mark replied to the thread Seat belt restoration.July 2023 - Little under $900 for front and back for a 70 Cuda Convertible. They did them in around 3 months.
-
Lunchbox replied to the thread Seat belt restoration.How long ago, what was the lead time, rough cost if your willing to share?
-
JJMB711 replied to the thread Steering Shaft Moves In and Out.My aunt caught me washing car parts in the kitchen sink once. Didn't hear the end of that for about 6 months... Ha!
-
6PKRTSE replied to the thread Interior Screw Identification.Luggage rack pedestal screws? -
AAR door, nice bottom lip, rot hole in front lower only. $350. No shipping. In Connecticut -
WWhiteGP replied to the thread Sudden Lifter Noise.It didnt have factory pushrods, it had some that were stainless ( came with the car ) and i really dont know how strong they were or...
-
WWhiteGP replied to the thread Sudden Lifter Noise.Hi Xcudme, I dont think i went above 5800 but maybe, that might explain the bending, good advice Thanks
-
WWhiteGP replied to the thread Sudden Lifter Noise.Yes i did i made sure of that, as i mentioned the motor was dead quiet before, i think i bent some push rods, pulling them now Thanks !
-
WWhiteGP replied to the thread Sudden Lifter Noise.Thanks, yea good idea. I have a set of pushrods i know are correct for the 440 RB, the motor was dead quit before I got a wild hair...
-
6PKRTSE replied to the thread Overhead console.Good post as I have to recover and restore my overhead console also someday.
-
6PKRTSE replied to the thread Sudden Lifter Noise.Are you sure it is lifters and not the rockers clattering? Did you re-install the rocker shafts correctly on correct side from front to...
