Recent content by 4sixty2fairlane

I got a 6.1 swap kit that had rad hoses with it. They won’t seal. Tried all the usual tricks. What hoses are you guys using? Both upper and lower are on pass side with a griffin rad.

Thats not a ram truck motor. The intake on the truck is taller and the throttle body points toward the pass side. I did a swap with a truck 6.4 in a B body and had to learn the hard way.

anyone know if this place is still in business? Located in klamath falls oregon. Phone numbers don’t work.

And just like on tv it’s finished.

Typical gapping issues.

Seemed like a never ending booth full of parts to paint. It wasn’t a 100% accurate just off the line resto. Just wanted to look clean.

B5 blue.

Obviously this is the quick version. The owner took tons of pictures.

Firewall and door hinge area was swiss cheese. Ordered one from Desert Valley. It was out of an ac car so i had to graft the two together.

The only floor pan that wasn’t replaced was the front passenger side

I forgot about starting this build post. Had to scramble to find allot of the parts but it goes to show almost anything can be built. I wouldn’t recommend trying something like this without a frame jig. I got the car finished a few years ago.

Did you find one yet? What was wrong with yours?

Any venders on this site going? I need some parts and would like to pick them up there or to/from there and Maine.

I had the same problems with challenger fenders from them a couple of years ago. One side was excellent, the other was terrible. Lucky I ordered them at a distributor and picked them up myself. I refused to take the junk one. Both were ordered at the same time with other sheetmetal and in amd...

I got a box of seat belts supposed to be for a convertible. Can anyone Id the stuff I have? I think I have some extra parts.