Hi Phil, do you have the Rare Defogger Switch with the 2 harness' as a package? If so, would you sell the whole package for $75? Please advise. Thanks, Ernie
Hi, I'm trying to upload the photos via this site and it's not letting me do so, it is saying the photo size is too big. I took several photos and I wanted to know if you can send me your email address so that I can send them to you. Thanks, Ernie.
Hello, I have a right side headlight bucket, which bolts to the fender and the bucket which holds the headlight. It has all the springs, adjusting screws, as well as the headlight ring. This is already restored, with labor and parts it will cost $450.00 USD. All you would need to do is bolt it...
Hi, this is the strut rod retainer. In order, 1st the pin; 2nd the nut; 3rd the retainer; 4th the sleeve; 5th the 2 bushings; and 6th the other retainer. One of the retainers has a smaller hole than the other. The picture above is just for one side.
Hi there! Welcome from NY! Here's mine couldn't be more prouder myself!! '72 440 Big Block TPI Fuel Injection built by me many many years ago!! @cudascott btw your's is awesome too!
The module you have is okay but the module needs btw 800-1500 ohm resistant pick up coil which is inside the GM Distributor. Within the distributor the coil has two wires which hooks up to the module for signal. The Chrysler distributor coil's resistance only has between 290-500 ohm, which is...
This looks like a welding rod for a stick weld. The coating is known as flux. Years ago some people used arc welding rods as a substitute for retention purposes as needed. This not an actual part for the car.