What are these from?

[V12T]

Pretty certain these two "wrinkled washers with a definite flat spot are from the front suspension somewhere - but where? They are identical,

so meant to be this way

 

[74 challenger]

torsion bars area?

 

[72tpi]

torsion bars area?

Hi, this is the strut rod retainer. In order, 1st the pin; 2nd the nut; 3rd the retainer; 4th the sleeve; 5th the 2 bushings; and 6th the other retainer. One of the retainers has a smaller hole than the other. The picture above is just for one side.

 

[moparlee]

What is the ID and OD of those washers? I don't think they are for the strut rods. Strut rod washers are heavy thick washers. Those look like the washers for the rear lower shock end mounting bolts.

 

[AUSTA]

Rear Shocks or depending on size torsion bar link washers that go under the rubber

 

[V12T]

Thanks for all help. ID=0.7" OD=1.5". I have the strut retainers which are bigger. They seem to fit snugly on the axle end of the lower rear shock mount - I have the other ends which is a smaller ID. Not sure why they're the shape they are?

 

[moparlee]

Thanks for all help. ID=0.7" OD=1.5". I have the strut retainers which are bigger. They seem to fit snugly on the axle end of the lower rear shock mount - I have the other ends which is a smaller ID. Not sure why they're the shape they are?

They got bent when someone was trying to jack up the car.

 

[74 challenger]

never seen a washer on the shock stud.