Does anyone know of any other companies other than PST (see link below) that make polyurethane motor mounts, or any really good aftermarket motor mounts? Thanks in advance.
Performance Suspension Technology
I will take a peek at my 73 chasis service manual sometime this next week. I have a vibration that resonates. As in it comes and goes for a second and then smooth and then back to vibrating again at 64 mph.
How does one adjust the rear axle bearings? I have the same issue as you did and have 3 degrees on both ends of my drive shaft as the tremec instructions for my tko600 that I installed. I was actually looking at getting new axles with new "green" bearings for when I put wilwood discs on the...
Looking at buying the Holley Sniper EFI system and also adding their Holley Hyper spark distributor so I could adjust the timing through the Sniper control module. I already have a CD box on my car, MSD6AL, and I was wondering if I would be able to adjust the timing through the Sniper module as...
Looking at making the switch because I am getting some light ticking out of the top end on the drivers side and I am assuming it is because we reused the original rockers fdom thw factory and they have seen plenty of miles.
Wondering if anyone has used these roller rockers from Comp Cams.
COMP Cams RP1622-16: Ultra Pro Magnum Shaft Mount Rocker Arms & Pushrod Kit Chrysler V8 273-360 (w/ Hydraulic Lifters) | JEGS
If so, has have they faired for you and how many miles do you have on them?
How easy are they to...