Recent content by Copilot

I really don't care for the reverse light lens on my 73, my plan is to modify the two extra brake/park light lenses i have to fit. I know they are different sizes, anyone do this mod before? Thanks in Advance

Thanks for the info. The Dakota gauges are backlit. Is the switch panel lite by the light bar? Do I need at least one bulb on the left side to light up the switch panel? Sorry for all the questions, I am brand new to the challenger world and I bought the car in pieces.

They light up the same surface area, why the extra bulb on rally light bar? Also I'm installing Dakota digital gauges, does it matter if i use a non rally light bar? Last question, does the light bar install first ? Thanks in advance

Headers installed, TTI great quality

The passenger side heater vent is drooped, will this straighten out once installed in the car? car is out for paint, not sure what surface it sits on Thanks in advance.

I have a 68 340 with X heads and need the four studs for the exhaust manifolds. what is the length? thread? I'm using TTI headers, not sure if that makes a difference. Thanks in advance

The listing at Classic industries advertise with intermediate cable and another listing without intermediate cable. Thanks in advance.

I have TTI long tube headers on my 69 charger for 15 years, 20,000 miles and no problems with coating or rust. I was looking at the shorty's for my challenger because I don't like the hassle of the long tube, as I mentioned above. Thanks

I think i'm just getting old and lazy. Thanks for the info.

I have TTI long tube headers on my charger (440). Kinda pain in the A$$. Heat soak starter, hitting the torsion bar on passenger side at idle. But remedied that with a torque strap, I think that is the correct name. Cannot remove the starter without loosing the header and jacking the motor on...

I have a 68 340 with X heads going into a 73 challenger. Q. Any issues with oil filter fitment? Q. what size tubes should I get, pretty much stock build Q Can you remove the starter without removing the header? Q. Any heat soak with starter? I have a Borgerson steering box but that should not be...

Has anyone used the seat belts in the link, or something similar? maybe from a 70's Dart? I do not want to use the original belt that attaches to the headliner clip thingy. 3-Point Retractable Lap & Shoulder Seat Belts

I built one out of metal, used a turnbuckel so it tilts foward and back.

Good afternoon, I have a stock 68 340, what type brand oil filter is good and reliable. Engine break in on Wednesday, builder said pick up oil and filter. Thanks in advance.

It has the holes in front of the hood for clips and holes underneath for screws. Is it the same on 70-71, holes in both locations? I have a new, aftermarket trim piece and with just using the screws it does not fit well on the hood.