Recent content by coyote42

Transmission and heads sold. Short block and new pistons available $700.

Thank you

I have the cast iron style. Outside is in great shape. Just want to rebuild.

Thanks but mine is in good shape. Just want to rebuild mine.

I want to get a new prop valve and distribution block for my 73 Challenger power disk brakes. I see some places only list for 70-72 but they look the same as my set up. I’m not finding any 73/74 listings. Is there any difference between years or can I use the 70/72 unit listed for PDB? Thanks

For sale; 68 383 + 72? 727. I went another direction after I started this and clearing up space. 383 is baked and cleaned, bored .040 and ready for final hone and ring fit, new KB pistons with rings, forged crank is untouched, stock rods, 906 heads need redo, intake, pan, water pump housing, 72...

It looks like for my 440 they don't have that shape the small blocks did. Steering looks to not go through. The hedmans I'm looking at have a similar shape to the Dougs and TTI.

Thank you

Well, that was helpful.

Hi guys, I am looking into a set of ceramic coated headers for my 440/auto 73 Challenger. I am looking at the Hedman Elite ultra duty. They are a thicker walled tube and I like the design of the tubes across the flange/ spark plug access and the ball type collector vs the TTI flat flange and...

That would be great if you could. I thought 70-74 were the same location, but one response says it may be different.

Really? Ok, thanks for the info. It does have the holes to put one there.

How much different and where?

I have found I am missing the bow that goes behind the dome light. I did not take it apart. Bought it this way.

Thank you, That's around what i measured.