Fit up is not going well…. I bolted the front pin location at 34” and the radiator mounting points at 28” but something is not right… the bottom of the radiator mount is not aligned correctly… I am reluctant to cut the drivers side but I can not see any other option.
Can anyone confirm that...
Of course I had to 'fix' the brand new stuff because I am smarter than the engineer that probably spent 1000 hours evaluating the amount of welding needed...
The cowl had some rust behind the fender aprons that I cut out, and also replaced the entire section on the right side that was damaged by a clutch failure.
Ended up cutting out a pretty big section on the right side to get back to clean metal. I suppose I could have replaced the entire cowl...
surprisingly almost no rust, but unfortunately hit in front somehow in the past that buckled/collapsed both rails bad enough that I could never bring myself to sell it if I didn't replace them both.
Thank you for the dimensions to check... that will help a lot.