Recent content by Cud@

I have a Gear Vendors Overdrive intermediate housing that the rear flange is up against the passenger side of the transmission tunnel (It's really tight to the passenger side of the tunnel). I took the brackets between the engine and isolators off a 383, could these brackets be wrong even though...

Hope someone can help me out! I'm installing a 440 in a 71 Barracuda with poly lock motor mounts and transmission mount from PST. I installed the motor into the K member with a 727 (motor mounts lined right up on K member with no issues) then lowered the body onto the engine. Now that the...

I have a Performer RPM intake off a 440 for sale, it's been port matched to the intake gaskets. I'm selling it because it's too tall to run with a shaker hood on a Cuda. My 440 is stroked (512 CI), runs a mild cam (488 lift), and a Holley 780. The engine produced 540 HP at 5,500 RPM, and 600 Ft...

Do you still want to sell the two bumper bolts? , I'm interested for $10

Huh, the 440 I used was from a 73 motor home and rebuilt before I got it. I'm sure the crankshaft was a cast crankshaft and it had a thin (15/16) balancer. Maybe it ran poorly at low RPM? i don't know because I never ran it with that balancer. Thanks for the information, glad you have your...

So was the factory cast crank balancer you swapped to close to 2 inches thick?

Hello RR70 I'm interested in the bumper bolts. Please call me at 320.241.9075 Thanks Steve

Please call me at 320.241.9075 Thanks Steve

Hope you figure out what the problem is, Good Luck!

I see the bolts now, looks good! Do you have the bottom transmission bolt too (7/16 - 20 X 2 1/4?

Thanks, looks like I'm really looking for the Action+ from Weiand.

Thanks, I really want the Action+ from Weiand

Anyone have a Weiand Action+ or Edelbrock CH4B intake manifold for a 440 RB for sale? Or know where there is one? Thanks Steve

I only need one of the transmission bolts because I have one. I'll watch for your response. Thanks

Hi, Yes I am interested, do you have pictures of the parts you have? I do need the rod for the 440 RB as I have the rod for the 383. Thanks