Recent content by dennispsalm91

Thanks for your post. It makes sense in regard to the check valve. I could hear it opening.

Putting fuel separator in 73 Challenger, is there a way to test it first? On the side where the 4 ports are. I can push or pull air easy. Where the 1 port is it seems hard to push air, but im able to pull air somewhat. It almost seems I can hear like a flap open while pulling?

The filler tube is aftermarket, im gonna check threads tomorrow. I thought one of the last cars i had, had screws in there. Unfortunately this car was unassembled

Thanks Adam, any idea of length of bolts? Also did you use a gasket between the neck and panel?

Yes im sorry, its for Challenger Im sorry i should have stated, it is for Challenger. I want to put on a Flip Top Gas Cap

thank you

Ok after finally wrestling the filler neck tube into grommet/gas tank, can anyone tell me what size the 4 bolts/screws are that mount the filler neck tube to quarter panel. Im going to install the after market flip top cap. Thanks ahead of time

YES

Looking for a clutch safety switch #3488177 for 71-74 Ebody

In search of a 1-2 side cover shift lever that will work for 73 833 trans.

Pair of green sun visors 40 plus shipping decent condition

Pair of rear tail light bezels, no lenses 40. Plus shipping

AC DUCTS ONE NEEDS A BIT OF REPAIR 200 PLUS SHIPPING

Several shields sold together small block as best as i know 45 plus shipping

Have actually 2 plates one set of the bolts 35 plus shipping