Recent content by Digem86

Here is a drawing with the measurements I'm looking for on a stock 15" Rally wheel. If someone has the trim ring depth for the same wheel I would appreciate it as well. Thank you for the help.

The car is running a 11" wheel in the back now with a 7 3/8" backspace, so that will not be an issue. If I run a 10" with a 7 3/8" backspace that makes the front 3 5/8 from face to wheel mounting surface. If a stock wheel from face to mounting surface is 3 3/4" with a 4 1/4" backspace that is...

Not a U code it started as a 318 car, when I purchased it a month ago it had the 440 so I added a Fitech 6 Pack setup and the Shaker. Now it's a V code with N96 option. LOL!!

I understand the 6 1/2" and 7" the reason I need to know the measurement from the face of the wheel to the wheel mounting surface is to get the exact measurement then I will order the backspacing to match the wheel width. and in the end will have the proper looking wheel finish.

Here are some photos, the wheels are going to be replaced with factory rally.

I am trying to order custom Factory Rally wheels for my 70 Cuda and need to know the correct trim rim that I can still order, and what is the dimension from the hub mounting area (back side) to the front of the wheel is to get the correct wheel and trim ring. Instead of back spacing it is the...

Hello guys after wanting a Cuda for over 20 years I have finally got my car. 1970 Cuda Convertible. The car was delivered between Christmas and New Years so now I can change the wheels to the factory Rallies and get the gauges working. Other than that I'm ready for summer. I'll be asking some...