Recent content by Gary Kitchens

I just realized that I have the fuel tank hardware in this bucket the filler neck hold down hardware so I’ll be taking that step here in a moment and collating everything together and then I’ll just put these damn shiny copper coated sample bolts somewhere where they match per Side and use the...

I don’t know why it quotes every time I hit reply I didn’t mean to, but every single one of the six screws you see their quarter 20 but they are self tappers and I think that’s because the factory balance didn’t have the screw holes in the rear pan because they fitted them to the three side...

It is a copper looking color and yes, I wire wheel them to clean them up prior to repainting so I’m not gonna anodize these balls and I’m not gonna put them through the chemical process when it’s not technically necessary but yes, they have the 4 to 6 fingers around the lip of the steel washer...

Here’s a picture of the full set that came out of the bucket that was not molested after it was removed from the car and I cannot count for the four screws With the built-in washer, nor can I account for the other seven screws three of which have the rubber glue on them to prevent them from...

I took this apart seven years ago and I did not notice this. Two of the quarter 20 bolts dealing with the rear valance and bumper have copper washers and this is confusing. There’s only two out of the set and I don’t know their exact placement. They have the grip tight fingers underneath the...

Dielectric grease primarily functions as a non-conductive, waterproof sealant for electrical connections, preventing corrosion and maintaining proper electrical performance. It's often used on battery terminals, spark plugs, and other connectors to create a barrier against Contaminants.

Die- dead- electric. No paseo?

It also helps electrical connectivity.

I am already aware of the grounding issues for all of the lighting and I have remedies for that and dielectric grease,

It is looking good though

Oh my God, I am so retarded. I haven’t even gotten to the point of the side marker lights, lol I gotta do some cutting a buffing before I put those in. I’m such a goober!!!

Does anyone of you magnificent and absolutely handsome gentleman have a 71 or 72 Challenger, with an unmolested trunk and tail light and Mel hardware? I need pictures or I need a description please.

I am reinstalling the tail lights and tail light basil and I need to know if anybody knows where the four domed nuts go inside the trunk. There’s four of them they’re about 3/4 of an inch tall with the small 8 inch dreads inside and they go somewhere because they came out of the boxthat all of...

I too am seeking 1 cone washer, i have everything else from the disassembly,

You absolutely rock. I’m gonna get the zinc because I think that’s what I pulled out I’ve driven