Recent content by Hemi T/A

check your messages

do you happen to have the original earlier headlight "panels " ? I need a set of 70 71 panels

I have been looking for a heat shield and am only finding ebay sellers with used items that want 5 and 6 times what the retail price for new ones were 3 years ago plus add the (normal for Ebay) , very inflated shipping charges and then the duty and the exchange rate on Canadian to US dollars ...

Im looking for an NOS or good used heat shield for the bottom of my 426 Hemi Intake . I have a new street hemi 2x4 intake but Im 99% positive the single 4 intake takes the same heat shield . Mopar performance part # P4529431. PM me here or email at [email protected] . thanks

The last picture of the argent version shows the engineering / part number and the Pentastar molded into the plastic . makes me wonder if the pictures are generic pictures of an original version or pictures of an actual reproduction grille with the proper numbers and Pentastar as part of the...

I didnt know there was a difference between a shaker hood spring and a normal hood spring ....

I am trying to restore a 1971 Challenger grille that has a small piece broken off and missing . I just need the last 6 " of the pass side end , that is below the headlight door . I will buy the partial piece or a whole grille ( in pieces or intact ) , any help or leads appreciated , thanks

what is the bore measurement ?

excellant info

can you pm me your phone number ?

wow , very good details . thank you

Ive seen a few Shaker hoods that have a center rib in front of the opening , this rib follows along toward the front and stops where it widens for a Pentastar to be mounted on it , Ive seen another ( in pictures ) that doesnt have this center rib and is flat with no Pentastar . Is this a model...

I removed the harmonic balancer on my engine as it was not an SFI balancer and I wanted an SFI one on it . I noticed after pulling the balancer off that when looking in behind the seal lip on the timing chain cover that there is an oil slinger on the crank snout . the slinger appears to have...

Thanks for the reply , I had a set of chrome repros that were not real good so I sent them to a chrome shop and had the old chrome removed by dipping and I worked the dents out of them and used black Wrinkle paint on them . they turned out good . Thanks anyway

trying to replace parts that were previously scavenged off my car, when it was under previous ownership . Ive tried to buy back the shaker hood and shaker that came off my car and the guy who has it refuses to sell it and is holding on to it for a future project . I've ordered an AMD shaker hood...