I am trying to get the front end back together on a 72 Challenger Rallye, I have the Dave Wise book and the exploded views of the grille pieces. There is no clear picture of the plastic valence or what it is attached with in either publication. The Wise book leads you to believe that valence...
Another question please guys, with regards to the blanking plates in the hood scoops. Why are they actually there? They have come in stainless I think, and installed would probably looked better painted black. Further, if installed do they just not restrict the airflow?
These plates are repros from National Moparts, I have tried them every way. Apparently another member on this forum says there is a right and left plate. This is my problem as they are identical. Thank you, I'll get back to National.
Thank you for the quick response, I thought about the paint but the difference is too much and the screw holes aren't even close. That is why I was wondering if there is a left and a right? Possibly they sent me two the same?
Hello folks,
I'm back cause I finally have some progress, here are some pics and part of my problem. Trying to get the hood inserts back in. The blanking plate went in fine on the left side, the right side not. The plates are identical, should there be a left and right side? Thank you for your...
Its been awhile but here are another couple of pics of my 72 Rallye. I chose the Holley Sniper EFI as the carb was missing. Drove it on the trailer this time for storage as I leave again for the summer. The front fenders are just waiting to go on and hopefully finish paint in Sept/Oct.