Mr Cuda's latest activity
-
I know it's not an E-Body, but my 98 Dodge Dakota SLT club cab has 200,950 miles on it and still ticking with nothing other than... -
Mr Cuda replied to the thread Mopar Engine Ruggedness.Indeed they are. At 200k, I did a slight refresh for oil leaks, motor mounts, water pump and the like. Nothing major, on a 5.2 magnum...
-
Mr Cuda replied to the thread ignition switch remove and replace.Remove lock star wheel and get to here on column. (shaft in is fine). Depress the lock cylinder dedent (small rod or drill bit) and pull...
-
-
Mr Cuda replied to the thread Steering Column for 1970 Barracuda Question.Auto columns are defacto lockout. The emergency flasher knob is 70 only. The igniton lock has a different release dedent holding it the...
-
-
Mr Cuda replied to the thread Replacing Lifters on 73 318.Are all the lifters slightly ticking? Do you have adjustable rockers? Could be lifter preload, or lack of.
-
Mr Cuda replied to the thread Replacing Lifters on 73 318.For pulling a lifter through the head, I have a KD lifter tool. Expandable barbs to catch the snap ring groove.
-
-
Mr Cuda replied to the thread Replacing Lifters on 73 318.But first, why are you replacing the lifters? Are they ticking? Is the lifter collapsed? A high miles engine could have valve seat...
-
The 1967 New Yorker 8-3/4" axle, like other 1965 - 1969 C-bodies, except 1969 station wagons, has a 46" perch to perch center dimension...
-
Mr Cuda replied to the thread C body axle.67 C+B with 440 (or hemi) use the 1330 u-joint
-
Mr Cuda replied to the thread C body axle.Thank you @Vaanth for your clear, concise and very thorough breakdown. In my old age, I forgot that 70 was the switch to the wider...
-
Mr Cuda replied to the thread C body axle.I used to save early C body rears to swap into cars with the toy 7 1/4. There are no more 70 318 or slant cars that still need a...
-
Mr Cuda replied to the thread C body axle.Chart is wrong. I don't have my DC book handy. Calling @Vaanth
-
Mr Cuda replied to the thread C body axle.If you have the axle, measure the spring pad center to center. The total housing width will correspond with the spring pad. 46-...
-
Mr Cuda replied to the thread C body axle.Actually, I'm not wrong. 47.3 is late C or 71 up B spring pad. (late C is B wagon housing width) 67-70 C is 46.
-
Mr Cuda replied to the thread C body axle.I'm suprised you need an 8 3/4" housing as all 72 up ebodies should have come with one. Unless missing? Or you just want the pumpkin?
