Recent content by Ted70challenger

Man look at the size of her trunk wew

I have replaced the engine bay harness years ago . I also added electric fans, msd ignition , ect , ect . Myself I simply made my own harness for all the aftermarket stuff and ran it along side with the factory harness. It looked good as I wrapped the aftermarket wires with similar non adhesive...

Typically when a engine overheats on the highway, the radiator is always suspect #1 . Me personally haveing gone through all this , would highly suggest a high efficiency core radiator. The fins are more closely spaced and the rows are more closely spaced to . It really is the best radiator you...

Thx for the input

They have been on the car since I bought it in ........1988 and there is no holes in the door other than the ones in the picture

This is the passenger side ( RT ) No holes . The door is on saw horses . I was cleaning up the jams

Hello I’m searching for two challenger side mirrors. Old ones are Black plastic . Which is fine . But there falling apart , I need replacements . I’m looking for something no so much original, but close . Any suggestions? Thx

That sucks for you . Maybe go to a car club or go to a local car show and ask for local referrals. Honestly that cam is tiny cam for 500 cubes . The extra cubes will make a cam seam smaller . Don’t be afraid of going over .5 lift . if you start removing rod or main caps then it’s rebuilding time...

Good for your buddy it’s fixed .

The wire is cheap to replace . But most likely the starter has problems .

Don’t get a ordinary radiator, spring for the high efficiency core radiator they do work better. also make certain the engine is not running lean with the air fuel ratio.

What is PUI?

And if you put the carb/filter in the scoop then you will need solid motor mounts. The engine will move 2-3 inches easy with the stock mounts

A offset filter base is what I did to center the filter in the scope. You can see it in this picture.

When I put on a hood scoop . I found out about how a engine sits 1.5” off center in the engine bay . There is several reasons why. But this sucks when your measuring your new scoop .