Xcudame's latest activity
-
Xcudame replied to the thread 70 440 Cuda Headers.Sometimes when companies aren't sure, they say they don't fit or say nothing. The 440 is taller so one would think the tubes would be... -
Xcudame replied to the thread Wiring Harnesses.For everything but the dash harness, Evans Wiring...
-
Xcudame replied to the thread replace ignition switch.You can do it. It's still not fun. You'll have to remove the obvious tomato can and then eventually you'll get to the lock plate and it...
-
Xcudame replied to the thread 70 440 Cuda Headers.Doug's Headers D452 and TTI have little to no fitment issues. The is some issues with Gen 3 hemi's, the Borgeson Box and Holley motor...
-
Xcudame replied to the thread WTB Thermoquad.Can't attach photos in PMs so this is what I'm sending.
-
-
Xcudame replied to the thread WTB Thermoquad.OK, personal message me you're address, and I'll mail the parts to you.
-
Many systems eliminate the tapered roller brgs & force the use of green brgs which is a Huge NO for me , they can interfere with the...
-
Xcudame replied to the thread WTB Thermoquad.@Old B5 circle what you need in the photo below and repost. Do you just need the linkage rod, thin washer and two clips?
-
-
Knowing that the rear brakes don't do near as much as the front brakes, I never considered going to the expense of swapping. I did...
-
I, too, have heard more stories of regret than joy putting rear disc on the e-body (and b-body) four disc, all-around, seems cool and...
-
Yep I have done it, never again unless I'm building a 200mph car, drums are fine for the rear in any application I plan on using. I did...
-
Xcudame replied to the thread Rear Disc Brake Remorse.Some of the rear disc brakes kits for the 8 3/4 use Cadillac calipers as they have a nifty built in parking brake. But they cause other...
-
Xcudame replied to the thread WTB Thermoquad.@Old B5 PM me and I'll send you the parts for the cost of shipping. I have dozens of "parts Thermoquads". Heck if they fit in an normal...
-
A good 5 or 7 blade clutch fan & shroud is more effective than an electric fan set up if it runs hot in traffic you need more airflow ...
-
Xcudame replied to the thread torque convertor bolts keep coming loose..Be sure to use a beam torque wrench. The click ones are usually off! As long as the needle is pointing at ZERO when you start, you'll...
