Recent content by ZNormT6

I ordered a new spring and button. Like you said, I think the button is stripped on the bottom.

The outside finish was just worn and It worked perfectly fine. When I screw either the old or new knob back on now it won't go into park or 1st gear. Then when I unscrew the knob a little more I get 1st gear but still no park. If I unscrew more the button flies off. The shifter works fine with...

Hi All, I am replacing the shift knob in my 70 Slap Stik Equipped Cuda. I got the old one off but I can't get the new one on. Please HELP! The button keeps popping back up out of the shift knob

After the new TS and Brake switch the hazards work beautifully with no more blown fuses!!! I also just installed LEDs in the dash and radio and they look amazing! Thanks again Chryco!

I was thinking the same thing. It kept blowing the hazard fuse whenever I turned the hazards on. I replaced the TS switch and after I get the brake switch replaced hopefully they'll work. I replaced the brake switch 20 years ago but the TS is original.

Ok. The the plastic connector on the red wires going into the brake light switch melted... Just curious if anyone else had this issue. Once I get the electrical sorted, I'll post some pictures of her! Thanks for all of your help Chryco!

Anyone?

Hey. I got a new brake light switch but I can't figure out how to take the old one out. Can anyone help me out?

Nevermind, Please Delete Thread.

I know this is an older thread but what flasher did you use for the Turn and Hazard? I would like to replace the Turn and Brake bulbs front and rear with LEDs on my Cuda. Thanks!

Ok. Thank You!

I went down to NAPA and got the 552 Turn Signal unit but, I can't find the Hazard Flasher. Could someone point me in the right direction? The one that came out of the car is a SIGNAL-STAT 175 S379 Thanks!

Hey guys! I found this under the dash of my Cuda and it wasn't connected to anything and I was wondering what it is. I found the harness that plugs into it and when I plugged it in nothing happened. Here are some pictures of it. Thanks!

Ok. Thanks!

I want to replace my flasher unit because the hazards on My 1970 AAR 'Cuda don't work, and signal lamps flash quick and sometimes and slow others.I was looking at the year one catalog, theirs is a round shape, mine is a rectangular shape, which fits into a sleeve bracket, that is attached to the...