i would wire the solenoid to stay on whenever the ac is on if you put a thermal switch to cycle the compresser on and off the compresser wire isn;t the best choice but will work you will have the problems i stated above
well it;s painted now i would leave it and put a wire tie on it .sassy green a great color the engine bay looks really good how about a pic of the car what have you done so far
i taped into the ac compresser power wire the only problem i have with that is when the ac cycles off at idle then kicks back on at idle the solenoid does not have the power to up the idle i have to tap the gas
i used tar paper held on with a few pieces of duct tape easy to work with .also they sell door hinge bushings and pins don;t unbolt the hinges just knock out the pins save a lot of time trying to adjust the doors
hi all i found my fuel line shield i know where it goes question i have is what is the mounting location look like that the hole with the pencil pointing corresponds to i replaced the trunk floor and extensions years ago must have thrown it out thanks for you replies
i agree with HPP 15 inch wheels work better with a 60 percent side wall tire ..i wouldn;t go with a larger rims and thin side walls it will be to bumpy of a ride
when raising the front take all the weight off the suspension before adjusting the torsion bars and count the turns on the adjusters .these cars sat a little low in the rear from the factory where does it rub ? what is your wheel width and offset ?