Search results for query: *

I figured it out....thanks

I have a few pictures.Does anyone know which one of these is the proper way to install this weather seal...

I'm also trying to find information on installing the weather stripping, it looks pretty self-explanatory.It goes in the groove at the top of the drip rails.. But after the bottom, it looks like you can unfold it and wrap it around the molding on the inside, not sure.If that's the way it goes or not

Unfortunately, I do not.I know how to adjust the glass in and out and up-and-down.I just don't know the position of the glass.Is it closer to the inside edge to meet the rubber or is it right in the middle... From looking at it , it looks like it needs to favor the inside of the car more to get...

When adjusting the quarter glass.. Should the quarter glass be adjusted to meet right in the center of the drip rail channel when rooled all the way up ?. I am attempting to make adjustments before I put the rubber in the drip rail channel... I guess what I am asking if you didn't have the...

Thanks for your reply.I will be checking them out further this weekend...

Looking for the three piece tail panel trim for a seventy three barracuda...thanks

Thanks for all the replies.I will get into a deeper and take some pictures.If needed....

73 barracuda with aftermarket market quarter panel install.. The factory wheel open trim does not fit at the lower section of the quarter panel in the rear.. it looks like the aftermarket quarter panel is straighter at the bottom inside corner than the factory is more curved like the factory...

Looking for the radiator overflow bottle and bracket that mounts on the driver side next To the battery....thanks

Ok thanks

It has the small hole for the smaller assembly.. I'm hoping I can do a return and get the small one.Instead.Thanks. i have been doing some research and can only come up with the one with the big one...

Hi , I bought a trunk lock assembly for a 73-74 barracuda , which is what I have..but....... Is there a difference between the 70-72 and 72-74....

Let me take another look to make sure. Here's another picture.The pieces I marked in blue or what I need for both doors.. Thanks for your time.. Sorry , that did not seem to be the right picture..

I am looking for the driver side front channel that is vertical from the bottom to the top... I'm also , looking for the channel that the glass mounts to that attaches to the regulator rollers that moves the glass up and down.. Thanks

Ok thanks.

Thanks

I think I found the right way they go.I have a couple of pictures if anybody would verify.Thanks

Good info there... I have the little clip post above the pinch weld, on three sides.. Just not sure on which way the clips go\nLooks like they can go two different ways

I am getting ready to put the front and rear windshield in and I have new trim clips, and I've been looking to find\n Where it shows the directions of the clips that gets installed on the little studs on or above the pinch weld thanks