Search results for query: *

I'm not sure mine is a 73 and it has the round circular ones..

This is\nWhat I was talking about if there was a flat clip , mine would work like this , but mine came with two round plastic clips

This may help... Technically , I could just drill a hole and that door structure brace and put that clip anywhere , but i'm trying to figure out where it would have went factory wise..

Thanks.I have seen all of those . Mine does have to plastic clips like in the last picture , but the cable is not long enough to route it down down by the hinge in the one picture. In that last pitcher, it looks like the one next to the door brace is not a round clip, but a flat clip.If I had...

On the mirror cables there are two plastic clips.. I have checked online and saw several different pictures. But nothing that shows where both of them go. There is one that shows 1 of the plastic clips going by the front hinge area. And one over on the door support, but it's not a round clip...

Thanks I really appreciate it...

I found what I needed thanks

He is right though I need to try to look the stuff up myself to see if I can find the sorrowest manual on line.I just thought you might have had it already... I appreciate your time and help thanks

You are right, just being lazy.I will look it up and see if I can find it. Thanks

Could I trouble you for the same thing you give me for the door glass as well?It would be greatly appreciated.Thank you

Thank you...

I figured it out....thanks

I have a few pictures.Does anyone know which one of these is the proper way to install this weather seal...

I'm also trying to find information on installing the weather stripping, it looks pretty self-explanatory.It goes in the groove at the top of the drip rails.. But after the bottom, it looks like you can unfold it and wrap it around the molding on the inside, not sure.If that's the way it goes or not

Unfortunately, I do not.I know how to adjust the glass in and out and up-and-down.I just don't know the position of the glass.Is it closer to the inside edge to meet the rubber or is it right in the middle... From looking at it , it looks like it needs to favor the inside of the car more to get...

When adjusting the quarter glass.. Should the quarter glass be adjusted to meet right in the center of the drip rail channel when rooled all the way up ?. I am attempting to make adjustments before I put the rubber in the drip rail channel... I guess what I am asking if you didn't have the...

Thanks for your reply.I will be checking them out further this weekend...

Looking for the three piece tail panel trim for a seventy three barracuda...thanks

Thanks for all the replies.I will get into a deeper and take some pictures.If needed....

73 barracuda with aftermarket market quarter panel install.. The factory wheel open trim does not fit at the lower section of the quarter panel in the rear.. it looks like the aftermarket quarter panel is straighter at the bottom inside corner than the factory is more curved like the factory...