Search results for query: *
- Users: Chryco Psycho
- Order by date
-
C
Cuda grill issues ??
If it has been replaced & it is difficult to tell you probably have a far better grille than 55 year old brittle plastic- Chryco Psycho
- Post #3
- Forum: Mopar General Discussions
-
C
New to the board
Welcome Dave , if it is an original 360 Chall they are quite rare / low production- Chryco Psycho
- Post #9
- Forum: Welcome Wagon
-
C
1973 Cuda Hood Inserts
I have often seen this , was it factory , Dunno- Chryco Psycho
- Post #2
- Forum: Mopar General Discussions
-
C
Ebay - Air Gap for 340
Ok I was wrong , not made in China but still not made with decent quality or materials Most I have seen , heads & intakes etc have bad core shift . 1 customer bought a carb where the fuel bowl wall was not cast so the counterweight for the air door was sitting in fuel , it had a quality...- Chryco Psycho
- Post #9
- Forum: Fuel and Air Systems
-
C
New member from Ohio
Welcome ! Love the 4 spd no console & the elastomeric bumpers !!- Chryco Psycho
- Post #4
- Forum: Welcome Wagon
-
C
Ebay - Air Gap for 340
I have never used one of these , I have used the Eddy RPM , Eddys use a soft alum & have poor port alignment , not high Quality so possibly this is actually made from better material or at least equal , could be the casting is more accurate also . If your heads have not been milled down this...- Chryco Psycho
- Post #3
- Forum: Fuel and Air Systems
-
C
NO LOW SPEED ON BLOWER FAN
Yes , the resister in the heater box us damaged- Chryco Psycho
- Post #2
- Forum: Heating / Cooling / AC
-
C
Pertronix timing question
Fuel has changed a lot too- Chryco Psycho
- Post #19
- Forum: Electrical and Ignition
-
C
AC for Hemi engine
You can run the small Sanden compressor , check wih Vinatge air & others- Chryco Psycho
- Post #2
- Forum: Mopar General Discussions
-
C
Project Slantfish nearing completion
Nice build it should run hard for a long time !- Chryco Psycho
- Post #16
- Forum: General Topics
-
C
Project Slantfish nearing completion
Did you mil the head .100 , I did , made a huge difference !- Chryco Psycho
- Post #10
- Forum: General Topics
-
C
Auto to Manual trans swap
If you have any room above the trans you can put shims in the rear trans mount , Less desirable is raise the front of the car using the T bars , make sure the car is lifted before trying to adjust it !- Chryco Psycho
- Post #2
- Forum: Transmission and Drivetrain
-
C
New from the Big Sky Country
Welcome , I used to live just north of you in Alberta , not any more tho !- Chryco Psycho
- Post #10
- Forum: Welcome Wagon