Search results for query: *

Keep in mind that the Barracuda trunk lock is offset and uses a different tail piece that operates linkage over to the latch, not a straight shaft that slides directly into the latch like most other models. It's lock is unique to that style of tail shaft, so, most of the aftermarket generic...

Yes.

Unless someone is going to be riding in the back seat, why worry about it? It's only an added safety feature for being in a crash, so, unrestrained passengers in the rear don't crush you against the steering wheel. None of the mid 60's and older cars had them, and it wouldn't (and doesn't) stop...

If it has an aftermarket quartz movement, I wouldn't worry about the battery drain too much. If it's a stock coil/points movement, they were notoriously trouble prone. The points would eventually stick causing the coil to melt down. Personally, if it still works okay, I'd make that jumper wire a...

I use my heavy duty snap ring spreaders for that job. Same one I use for automatic transmission rings.

The PM prefix was used in both 1968 and 1969. If 1968, they didn't put the VIN on the block. If 1969, it's still not the original engine. It should have F318 as a prefix in 1970. How about a second look at the casting number and maybe posting it here. Sometimes 68 and 69 can be confused if the...

Your cover is a late '68 or '69 small block cover. Looks like your replacement was made in 1983. Just match the cover with the correct balancer or remark the one you have if necessary. It's always advisable to verify TDC on any rebuild or parts swap anyway. Use a piston stop to check it.

My heads have an "F" after the3418915 F What does the F stand for?? From what I've been able to determine, it's the particular casting mold for that head. They progressed through the years alphabetically. I've never seen an A mold, but, I've seen B molds, all with 2.02 intake valves. On the...

3418915 casting 340 and 360 head 1970-2. They were machined for both 1.88 and 2.02 intake valves depending on year and engine.

bump

bump

13 used are sold. Have 6 used and the one NOS one still available.

These are the tape player bypass plugs that go into a radio that is equipped with a pigtail for the remote cassette player. Without the tape player cable hooked up, the radio won't work without this plug. As you can see, I have quite a few used ones, and one NOS one. $10 ea. for the used, and...

Still for sale.

A nice original '70-1 Cuda jack hook 2931100 that's been repainted and ready to ride in your trunk. $75 picked up here in San Diego, Ca. or add shipping and any PayPal fees. I ship to U.S. addresses only.

This is a nice original '70-1 Challenger jack hook stamped 2931102 that's been repainted, ready to ride in your trunk. $75 picked up here in San Diego, Ca. or add shipping and any PayPal fees. I ship to U.S. addresses only.

Sale pending and PM sent

Price reduced to $75.

New in box 4494 in dash tach. Made in USA according to all the logos on the box. $350 picked up here in San Diego, Ca. or, $375 delivered to a U.S. address only. I take PayPal and cash/Venmo in person.

This is for one NOS rear side marker light for the '70 and early '71 Barracuda, Cuda,. and AAR. It fits either side. $85 picked up here in San Diego, Ca. or add shipping and any PayPal fees. It will fit in a small flat rate box from the post office ($13). I ship to U.S. addresses only.