Search results for query: *

For some reason , it will not let me upload anymore photos.I will keep working on it

Thank you that's very helpful

Thank you...

Does anyone have any pictures of these being installed...

Ok thanks

Thank You..good read.

Just trying to figure out the best way to install these.. Any suggestions on should dos , or must dos.. Or would do if I was you l o l...

As I mentioned earlier about 3 out of 5 cars , I looked at do not have the trunk extensions and our finish and painted.. I was just curious of how they were put together where the two meet at the bottom of the quarter panel

So I have decided to put trunk extensions on my project. I have a question.\n I saw a couple of videos where the trunk extension and the quarter panel at the bottom were not welded solid together. Does anybody have a thought on how they are done or supposed to be connected to each other?The...

While installing the rear valance, I realized that There are no trunk extensions installed.. It had new quarters, and trunk floor that was already installed when I got the car.. As I was looking at pictures on the web , I noticed that about three out of every five pictures do not have trunks ...

Thanks....

Lol sorry about that.There is only two phillips heads , and I think they go in the center of the valance where the two brackets are and the other two hex screws go on each end.. I guess that's not really a question.Rather needing verification , l o l...

I recently bought a mounting kit for the rear valance. It has 4 nuts 4 studs, 2 smaller hex bolts and two smaller phillips head bolts.. I know where the four studs and nuts go.. Best I can figure is the two smaller phillips head screws go in the center supports and the two smaller hex bolts go...

Thanks

The new shock fits the cross member perfectly.\nAnd you can put the bolt through easily, the new shot does not have the washers.. too Me it looks like if it had washers on each side of the shock , it just seems it would be\nBetter reinforced..

Lol now i'm just curious, is it something that could have been used or should have been used by taking the old?\nSleeve out of the shock and taking one washer off of that piece and slide it in the rubber on the end of the new shock.. I don't know..lol

Ok thanks

I am slowly putting this seventy three back together, working on the rear shocks.. There were no shocks on the car when I got it.. This is what I found in the upper cross member where the shocks go with a bolt going through in a nut.On the other side.. Not.l, Sure what it is unless it is part of...

Thanks..