Search results for query: *

So i've got 12v on the red on both sides of the plug.. And only 6.5v on the brown wire coming from the plug with the key in the position.. so the Brown wire gets its power through the Ignition switch Correct?Possible ignition switch issues

I have 6.5v coming from slot 22 the brn wire from the firewall to the ballast. I have 12.65 at the battery.. And I have the same volts on the red wire.. Going to the ignition switch .. But only have 11.5 on the fuses.. When I touched the positive cable to the battery with the key on or the off i...

Ok thanks alot

So after a little bit of time, I finally got the new wine harness installed new ballast resistor new starter relay. And came the grand moment to start when I tried it , it lit off as i'm holding the key in the start position stopped when I let up.. I'm sure it's been discussed a lot of times...

Thank you...

I have a new neutral safety switch wiring harness that goes from the bulkhead down to the transmission. My question is, there is a white plastic hanger that is made into the harness. It looks like it hangs on something.I am looking to find out where that wiring harness hangs at on the firewall...

Wow thank you.. That could not have been a more perfect answer to my questions....

I am looking for the proper hose routing. For the spark thing on the passenger side firewall.. As well as the routing for the hoses from the fuel canister.\nTo the carburetor.. Also, the vacuum temperature switch on the radiator has 2 hoses not sure where they go or how they are routed.Any help...

Looking for factory headlight wiring harness mounting tabs that go along the inside of the radiator core support and on each side.. I believe they are bendable with a rubber coated tip.. Maybe from a used core support in here, they can be drilled out on\nThe spot welds i believe...

Ok thanks

Cool thanks

For some reason , my seventy three does not have any that does not mean they were not there at some point.. Any ideas of what I could do instead would look decent

Thanks what about the headlight wire harness that goes across the radiator core support what clips are used thanks

Does\nAnyone have a picture of the wine harness going over the brake booster and through the wiring bracket?That's mounted to the brake booster for a 73 barracuda.. Also I would like if possible to see how the wire runs from the starter over to the solenoid and the battery thanks

Looking for a single gray tach wire that has the correct male end that will go into the firewall bulkhead.Connector and has the proper eyelet in for the coil.For a 73. barracuda... Thanks for any help

This is what I found online..

So I put it back to where I found it.I would still like a good explanation to why they do that if anybody has one thanks

I am going to put it back the way I found it

II am wondering why they would put the taper.\nToward the rear end and should\nI put it back that way