Search results for query: *

No Worries !!! Thanks for the info

Thanks, good info, I'll look up the speed pro pistons... found these 1970 PLYMOUTH CUDA Sealed Power L2355F Speed-Pro Forged Pistons | Summit Racing didnt find the 2244

Well, no issues with the lifters at all. Canada Nick mentioned a spun bearing within 30 seconds of our ( quick ) conversation and I think he's dead on. Soooo off to Mopar Keiths shop when he has room for me ( Sorry Nick, your just too far away :-) ) This is a U-Code and I will want to put...

Well looks like your right, 3.23 is the lowest so that settles that !! Not really worth the $$$

Thats Interesting !! Good Info, Thanks

OK, so here's where we are. Pushrods fine, no oil filter issues, i know its a small cardinal sin but going to install new lifters, i pulled one and it looks brand new but thats what Im down to? I KNOW someone has been into the engine before I bought it. Last ditch idea. The car is...

Ditto with the No Issues, Love the Borgeson upgrade

Was it the 70 thru 74 E Bodies car or did it go back to the formula S cars ???

Pushrods were good and i installed new to be sure, Well, Im going test the faulty oil filter idea tomorrow, I have less than 150 miles on the current oil change. The rockers got plenty of oil when i fired up with the new pushrods so the noise maybe has to be from the lifters not getting...

Well, Im going test the faulty oil filter idea tomorrow, I have less than 150 miles on the current oil change. The rockers got plenty of oil when i fired up with the new pushrods so the noise maybe has to be from the lifters not getting enough oil to pump up ( i.e. filter running thru the...

Well, not bent pushrods, I put new ones in anyway, same same, both sides, i'm wondering if the lifters arnt getting enough oil, plugged oil filter ?? the oil is clean and filter fairly new but ?? I will try replacing that next ... Going to the drag races tomorrow so a day off :cool:

Thanks Pyscho :-) I have the rockers off on one side and everything looks good so ?? I'm installing new pushrods and re tourquing, will see. I'm needing a good reason to rebuild the engine anyway so will see what happens

It didnt have factory pushrods, it had some that were stainless ( came with the car ) and i really dont know how strong they were or what brand, ill just replace them with a factory set of sealed power i have if bent, if i replace 1 ill replace all

Hi Xcudme, I dont think i went above 5800 but maybe, that might explain the bending, good advice Thanks

Yes i did i made sure of that, as i mentioned the motor was dead quiet before, i think i bent some push rods, pulling them now Thanks !

Thanks, yea good idea. I have a set of pushrods i know are correct for the 440 RB, the motor was dead quit before I got a wild hair and stomped on it one day ( a few times ) The push rods that are in it appear to be stainless but ? maybe not hardend enough ? I'm pulling the covers now....

I think its only some, bent pushrods make the most sense, im going to open it up today. fortunately i have a spare set of pushrods :-)

Thanks, Yea I think your right, Im going to tackle that tomorrow, I have a set of gaskets so I'll just pull the valve covers and re torque , i'll post what that does, I have a set of pushrods and a spare rocker assembly ( somewhere ) also if needed No oil laying on the heads I didnt...

Hi All Per a previous post on valve train noise, I replaced the even side rockers and shaft. The 440 instantly went silent and purred. Suddenly both side valve trains have gotten noisy, i mean just out of nowhere. I checked oil level, and oil pressure ( runs about 60 psi, always has ) and...

thanks