Search results for query: *

I just ordered a new switch plate. Thanks for your help.

It looks like they no longer carry the decals. Thanks

I checked their website. Unfortunately, they don't carry the stickers for a stock dash panel. Thanks.

Does anyone know where I can find a sticker or decal for the headlight, wiper, and dimmer? I plan on painting the panels and would like a new decal. Thanks

I think it's a 1/2 fine thread. I had to clean up the threads on the shaft and the nut.

I have a piece of thick rubber gasket material. I'll give it a try. Thanks

Thanks

On my 70 Baracuda,I pulled my dash to have it redone and to look for water leaks on the firewall, that I couldn't find from the outside. I noticed a big gap between the defroster vent and the heater vents. Is this normal? If I recall correctly, my defroster did work. Thanks

I found a couple of problems. Two jumper wires I used to ground the turn signal were bad. The other problem I found, there was a bad ground wire near the connector. I had previously checked to see if the wire was grounded, using a multimeter. Thanks for your help.

Thanks, great info. I'll check out the testing the circuits tomorrow.

Sorry, I forgot to mention this is a 70 Barracuda. The turn signal/driving lights are a little different, There is a separate ground wire for the bulb housing. I'll check but I don't think the bulb is in backwards since I didn't remove it. The turn left signal indicator comes on also with the...

When I turn on the headlights on, the left turn signal indicator on the dash goes on. If I put the indicator in the left hand turn position, the indicator light goes off but the left turn signal doesn't work on the left The right side is fine. If the headlights are off, both turn signals work...

Thanks. I was leaning toward AMD.

Are the three different trunk lids due to the spoiler or no spoiler option?

I need to replace my trunk lid on my 70 Barracuda. Has anyone used Auto Metal Direct, Sherman, Goodmark, or OER? Any pros or cons on these companies? Thanks

I'm pulling out the carpet and the sound deadening material. Thanks

Here are some more photos. I think you are right. It looks like the torsion bar crossmember.

I'll send a photo after the holiday. Have a happy holiday.

I went to the AMD website. Is the part I need the floor support?

On my 70 AAR clone, there have been many patches made to the floor and the frame. It looks like both quarters have been replaced, the truck floor and the rear floor has been replaced. I found that the frame on the drivers side needs to be repaired. Can this be repaired by welding some plates of...