Search results for query: *

Does anyone know where i can get a drivers side motor mount for a 426 hemi. Broke it last week reinstalling the engine. K member was for a 440 but a kit was purchased and fit perfectly. Apparently the guy I purchased the car from is no longer around. apparently the kit was purchased from a...

Is there a site I can get some information on how to put together the new shaker I have purchased for my Cuda. I am converting from a rally hood. I purchased and installed the shaker hood. Now all I need to do is figure out the shaker portion that goes on the carb. Lots of parts, screws and...

Hi Guys 2 years ago I dropped the 426 hemi out of my Cuda. Just put it back in today and I can't remember which inlet on the mechanical fuel pump the fuel line from the gas tank goes to. The inlet on the pump that is closer to the front of the car points straight down and the inlet just behind...

Spring is here and time to do the regular maintenance before starting up the engines. Every year I get a different story on the type of oil I should be using on the old stock 68 hemi. I have even heard that some guys are putting diesel oil into their big blocks. Some say to add a ZDDP...

I am looking for a cuda dash pad for a 72 Cuda. Must be black and in good condition

Just checked the compression on my 426 Hemi. Drivers side each cylinder is about 150. The passenger side each cylinder is 115. Big difference especially since the engine has just been done and has less than 100 miles on it. Any suggestions on what might be the problem or cause.

I need some advise Just installed a 68 block 426 hemi into my 72 cuda. Engine was totally rebuild from ground up and installed by a friend of mine. The engine was machined by a shop that went bankrupt while my engine was in the shop. It took almost a year to get it back and had to be put...

I am looking to swap a out a 440 for a 68 hemi engine into my 1972 cuda. I would like to use the existing 440 K-member. Where can I find engine mounts that will allow me to mount a hemi engine on a 440 engine K-member

I am looking to swap a out a 440 engine for a 68 hemi engine into my 1972 cuda. I would like to use the existing 440 K-member. Does anyone know where can I find engine mounts that will allow me to mount a hemi engine on a 440 engine K-member.