Search results for query: *

Good evening, looking for a NOS fuel filler neck trunk floor seal part number 3466151. Thanks in advance.

Hi everyone, just throwing this out there again looking for an Original F7 Sherwood metallic green touch up paint container. I do see many greens out there, but not F7 green for the 71-72 years. Thanks in advance.

Hey guys, looking for a nice OE gas tank for my 71 Cuda. Thanks in advance...

Hello guys, looking for a OE fuel line running from fuel pump to fuel filter for a 71 Cuda 340 engine. Thanks in advance.

Hello Guys, looking for an OE correct fuel pump to carb fuel line. This line comes out of the fuel pump and ends at the fuel filter. This line runs beside the alternator and has specific bends due to the tight areas. Thanks in advance.

Hello Mopar friends, I was installing my engine this past weekend and had an issue with lining up my K frame bolts (3 ok \ 1 not ok). I built a jig and installed from the bottom with transmission attached. The main question is, with the weight of the engine/ trans already on the K frame, alter...

Good afternoon Mopar friends. Has anybody come across a small gap with lower bolt on clutch / brake support bracket during install? Everything is OE , I don't just want to tighten up with this gap. Am I missing anything? Looked at some illustrations online and I don't think I am missing...

Hello Mopar friends. Just in need of a little advice. I ran my 340 engine on engine stand to break in and all is good. Looking for advice to use conventional oil or synthetic moving forward. Also what weight / viscosity. Thanks in Advance....Bill.

Good evening, looking for very nice 71 Cuda date coded mirror glass. NOS or very nice used.....Thanks in advance.

Good evening Mopar friends, I have a picture here of my original rallye cluster from my 71 Cuda. This car had a 1984 inspection sticker on windshield when I got it. Can someone tell me if this mileage turned over past 100k? I thought I heard it turns a color that tells you it past 100k mark. Is...

Good evening all, would anybody know where I can get the male pins for the drivers door jam switch on a 71 Cuda? This would be the harness side male 3 pin connector. Just trying to avoid buying a complete used harness, unless I have to. Thanks in advance!

Good evening guys, would a SRT7 chestnut brown leather interior be more on the common side on the 71 Cuda to be ordered, or more on the rare side? Exterior is GF7, just curious, also ordering it soon from legendary, hopefully not a hard color to get. Thanks in advance.

Hey guys, I'm trying to figure out the exact By Plymouth tail panel emblem color for 71 Cuda. I believe the tan color one is for Cuda's, but I have seen the black color emblem on some Cudas. I have seen in a few places, one stated Black is for ebodies, and Tan is for B bodies. Today on ebay it...

Hey guys, would a F60 -15 Goodyear Polyglass tire fit on a 15 x 6.5.Rallye rim? I believe this tire came on the 15x7 rims from factory. Thanks in advance.

My 71 is coming along, just got it back from body and paint. Thanks for your help and advice guys! moving on to drivetrain and interior soon. I'm sure i'll have more questions along the way. Little by little getting there!

Hello all, looking to see if anybody has a factory spec for location of rear gull wing on 71 cuda. I did locate the one for 70 go wing, but not the 71. Or if someone has a factory gull wing car could you send measurements. Thanks in advance...

Hello Mopar friends, does anyone know the top aftermarket wheel well mouldings for 71 Cuda? I have bought 2 sets and they are not even close. I even paid a little more for the better quality, still not close. Any suggestions? Thanks in advance....

Hello Mopar friends, I'm am in need of a left front side marker light assy in nice condition. No broken studs, with nuts and decent lens / light amber / orange. Thank you in advance.

Hello Mopar friends, I have been looking out there to find mounting locations for the rear Gull wing and side door mirror locations (71 Cuda) with no luck . Does anyone out there know these locations? If anyone has the info or site, it would be very helpful. Thanks in advance!

Hey Guys, I know i had sent this out before, but its worth a shot again. Looking for an original gf7 sherwood green metallic touch up paint container. I know these are hard to find. If anybody has one or knows where to get one please let me know. Thanks in advance.