Search results for query: *

on 3rd ballast resistor. new one installed when hooking up wiring harness. no good. was very hot. tested no good at store. #2, first start on the rebuild. timed and adjusted carb. spent part of day starting engine.Been I shop for about 10 days everything was fine. Ralley gauges worked. tried...

trying to get the "71 running..power Steering box leaking. Napa list one for $149.95. But none in stock. need a source. seen a new smaller one advertised for $650--option. is there an alternative to the power system or just manual .??

shop that did the engine work, removed the oil filter to block assembly. went through 3 different oil filter to block plates held in place by threaded bung[ 3/4 inch nipple] . went through 3 different adapter plates to block. the last one did not leak when just rolling over the motor. over. when...

parking lights and dash lights [rally dash] come on with ignition on. do not remember this. replaced oem dash with rally dash.

lost the original hood release cable. ordered a new one. it comes with a loop at the end. can make it work. HOWEVER, when is disassembled the car, I have a memory of the cable attaching to the back of the hood latch. it was a bit of a struggle to get it undone from the latch. can't find any...

asked this before--need set of headers for my 71 challenger small block--360 heads---. set I bought, the pipe was dead tight against the torsion bar on both sides, no gap whatsoever. need suggestions.

this is a gap on the left side upper windshield trim. this is the original trim. --car never wrecked/original owner---. right side fit ok. what can I do to fix this problem????????

know where these go, but what is purpose--extension of rain rail? found screw hole on right side, but left is gone. tried to find it, can't remember if it was bond-oed over. may have to drill a new one once positioned.....next---how far down does the rainfall go down in the front. lined up...

this goes behind the window crank. only found 2. if I remember there were also behind the rear handles. what is the proper name and who might have them. 71 Challenger

what kind of fasteners hold down windshield trim above wiper actuator ?

starting on the drivers side door panel. examined closely for a indication for the joy stick position--no such thing. have clip in place to hold cables in place. --- Need dimensions for placement...........right side panel on. bit of an ordeal to get those bottom spring clips in place

is the door pull attached to the door panel, or is it a separate piece held to the door frame by 2 screws????panel fits very goo--test fit--- does the rubber weather seal go on top or under the panel. anything I need to know before final install??

how is the cable routed. tried under window--nope---to the front side--nope. there is a small clip that goes somewhere to hold the cables in place--where??? Also need to have location for hole in door panel to mount the actuator

how are these positioned

getting ready to install the interior door trim. painter the door pulls.,, have the hem arm rests. pretty good shape other that dirty looking. scrubbed them with Dawn, but still stained....can these be painted. different material that the plastic parts.

put headers on my '71 Challenger small block. the ends of the pipes were tight against the torsion bars on both sides. no air gap at all. friend gave me some manifolds--part #53010187 left and 186 rt side. are these good bad or ugly. I know its a matter or personal preference....Suggestions...

what is the correct position of the bracket that bolts to the door frame? have one arm rest screwed to the panel but what are the Bottom holes for?

have new end caps that are peel and stick. are the old ones removable??

what is the purpose of the electrical connections on the heater box

cannot get power to the fan motor. according to the wiring diagram all wires are in the correct position..cannot get power to the blue wire at #4 position on fire wall harness. have good ground, hot from battery to fan, it comes on