Hope someone can help me out!
I'm installing a 440 in a 71 Barracuda with poly lock motor mounts and transmission mount from PST. I installed the motor into the K member with a 727 (motor mounts lined right up on K member with no issues) then lowered the body onto the engine. Now that the...
I have a Performer RPM intake off a 440 for sale, it's been port matched to the intake gaskets. I'm selling it because it's too tall to run with a shaker hood on a Cuda. My 440 is stroked (512 CI), runs a mild cam (488 lift), and a Holley 780. The engine produced 540 HP at 5,500 RPM, and 600 Ft...
Anyone have 2 of the bolts that hold the front bumper brackets to the frame on a 71 Cuda (I'm not sure if 70 thru 74 are the same?).
I also need the 7/16 - 20 X 2 inch bolt (measured from under the head of the bolt to the end of the threads) that secures the ear on each side of the block to...
Wanted - Kickdown pivot bracket assembly on driver side of bellhousing on 727 automatic transmission.
The engine is a 440 RB if that makes a difference.
Thanks
Anyone have the transmission kickdown pieces that fasten to the driver side of bellhousing on a 727 automatic transmission? I need the part that threads into the bellhousing and the part that pivots on it (I have the rod that comes from the pivot at the rear of the throttle bracket, and the rod...
Just thought I would ask if anyone knows whether or not the anti tattle clips are necessary on the outside of the front disc brake pins that hold the caliper and brake pads in place. Seems not too many people sell them and they are expensive plus when I removed the front calipers and pads from...
Before I install PST's quick ratio Idler and pitman arm on a 71 440 Cuda with TTI 2 inch primary header rubes I thought someone out there might know if there are any issues I will run into? I would appreciate any feedback.
Thank you
I need some help identifying how the lower ball joint is attached to the spindle on a 71 Cuda with disc brakes because my car has been disassembled for about 20 years. My question is are there washers between the nut and back of the ball joint where the ball joint attaches to the spindle or is...