Search results for query: *

Love your work. I turn 60 this coming Saturday and i too love to work on these cars. I dont golf, I Moparize!

I have a complete QA1 system on the front of my Challenger minus the rack and pinion. I really like it for the ability to really tailor the alignment specs. I am actually looking at installing the complete system with the Rack & Pinion on my 71 C10. I cant seem to find much information on the...

Awesome

Perfect. My system is a 6AL. Thanks for the ideas and the help.

My ignition system is an MSD. Will that still work?

If i wanted to hide a grounding switch somewhere on the car to help with theft, would i ground the coil? I have a battery master switch already, but feel like that is where someone would first look.

Great advice. I am tackling it tomorrow.

Whats the easiest way to get a 1 inch lift on the back suspension? Raising the car 1 inch in the back shows the tire a bit better and gives it a slight rake look.

Thank you for the help.

Thank you for the help

Thanks, I suspected that i probably wasn’t paying attention to where the blade position was when i installed the bar.

Yes, I replaced the bars.

I have the height adjusted on the front of the car at 24.5” on both sides fender lip to ground. Car level and have rocked it up and down each time i adjusted the tension. I also lifted the front of the car off the ground each time i adjusted the tension bolts. The passenger side bolt is 1.75”...

This is an old post, but i am following some of the posts for the Torsion bar install. Have a question. I followed the procedure, but i find that i have the driver side turned in almost 1.75 inches more than the passenger side, to get the same ride height. Would the torsion bar need to be pulled...

Haha good to know. I wont be worrying about that

Thank you. I dont have that in my seats so i won’t worry about that.

On my old harness the connector is white and the wires are blue, blue/white, and blue/red. On the new harness the connector is black, and I cannot find anything under the dash that it may plug into. On the old wiring the blue/white connect up with several other similar wires and trace back to...

I have all the relays and wires connected to under the dash. I cannot find any more wire connectors for this relay. I am not even sure what it goes to.

I got all the easy stuff wired to the brain box. I just wasn’t sure about the turn signals. I installed a new MH dash harness, so i have my old dash harness that i have been unwinding so i can trace wires and learn how this all comes together. It’s actually kind of interesting. I wish i had more...

Anyone have experience with wiring the Dakota digital brainbox? I have it pretty much complete, other than the lights and turn signals. Not sure how to add these in. Would i just locate each turn signals wire coming from the column and splice in? Same with the high beams? the directions that...