Hi
Anyone have a good close up picture of what the grey painted surface on these wheel covers looks like. Im restoring them and know they were painted a grey, Just dont know what grey. Some people say its argent grey like the grill
Thanks
Hi
Are all cost hangers in cars black? or did the factory die or paint them to match interior color?
I was missing mine so i ordered them from classi and they are black
Hey
I finally got it all together
Got no spark
all new wiring harnesses from bill evans. seems like it got it all correct
new petronic ignition
when key is in the on position but not cranking there is no power at either side of coil but there is power at both sides of ballast resistor with...
Just rebuild 1969 440 engine. Stock Setup.
I understand that zinc should be in oil for break-in period and possibly longer.
I purchased Castrol GTX SEA 10w-40 Oil
Does this have zinc in it? Doesn state on bottle. And if it does is it enough for break in?
If not i did purchase Lucas Zinc...
Hi
I need to restore 4 of these hubcaps or wheel covers
Anyone know who can do them?
Also what is the correct color and finish on the outer part of these? I drew an arrow on picture. I think its a dark grey possible argent like the grills?
Anyone know
Thanks
Hi
Can someone tell me based on my broadcast sheet attached what numbers are two be written on value covers with grease pencil
the passenger side or right side I believe is "915"
I dont know what numbers goes on drivers side
Thanks
Paul
hi
Just wondering if anyone has good pic of dashpot installed? I assume it has just to screws holding it down and its installed prior to carb going on because the screws are under the car at least the most forward one is
I installed my torsion bars
I installed new adjustable new torsion bar adjuster blocks and screws
Before i adjusted the height, the front of the car was low
I lifted the car to take pressure off the front end
I adjusted the torsion bar screws in lower control arms and car started to raise as...
Is the engine color for 1969 roadrunner supposed to be blue or orange in color? I have seen them both ways. My car was produced in St. Louis so maybe it was different from assembly line to assembly line?
I dont have built sheet on car either
Thanks
Hi
Big question is
There are 3 metal splash shields under the front fenders.
Were they black in color or body color?
If they were on car when it was painted I guess they were body color
If the assembly line workers put them on after paint then I can see that they were black?
Thanks
Paul
Hi
For 1969 dodge charger fuel filler neck. I got a replacement one. It shinny in appearance or bright.
What was the original finish on these? Dont know if this is correct
Hi
Anyone have a good picture or pictures of the simple rear license plate light install? There is a bracket 4 screws, lens and housing
Dont remeber how it went together