I am restoring a grill and not sure of the lower grill egg crate section both L & R -is this black or is this just all argent silver and a shadow making it look black?
My 340 has no dip stick tube or stick-any ideas what is the part number or what to use for the tube, stick and I assume bracket to hold the tube-any info helps-
70 Cuda-
Horns
L & R fenders
340 dip stick tube and stick
Spare tire pivot long bolt that goes in the trunk floor
Front and rear window trim mounlding
Back panel trim moulding
Grill
L & R front park light clear plastics-encases blinkers
1 red 1 yellow marker light complete with pig tail plug...
[Back to the grille-I did see a broken in half grill with the centers on ebay that was fairly cheap-but-somehow gluing all those slates might be a PITA-what type glue for repairs and or fillers that are easy to apply and use would you recommend? I think it would be easier to buy a new grill-
Is this even worth fixing? Also I see you do hinges- I bought new 70 cuda hinge pins and bushings is this all that is needed to rebuild a cuda door hinge? I have done some older Chevy trucks with same process but I just do not see any info or details for doing a Cuda door hing but they sell...
My stock grill seems to have been altered from pictures I see of new grills-and the issue is the long center rectangular grill areas both left and right which have the cross hatch sections-both sides of these are missing in this area-and this grill has been repaired before but where these cross...
I bought the bubble on ebay and I think its made to order-I hope what I bought has the mounting points for the small vents-otherwsie it may turn into a JB Weld special-
I also bought vents on ebay from a seller there who seems to specialize in plastic injection molded parts of all sorts-
Great pictures -thanks so much- what size diameter is that orange air cleaner lid or part number and what is the height or part number of the air cleaner itself -
If the bubble bolts to the plate it sounds like to get to the air cleaner you have to unbolt that that bubble rather than wing nuts? What holds the base plate in place is there a ring clamp around the carb under that plate, or is it held in place by the air cleaner wing nut and cap and unless...
I am in Southern California-
I have some original decent side marker metal main housings all sand blasted - I prefer to trade and I need 1 yellow and 1 red marker light housing with the lens and electrical wire connector-
Other parts I have to sell/trade-
Cuda deck lid -straight but rusted to...
Any advise on these details are welcome-70 Cuda 340 project
I picked up a converted shaker hood today with trim ring installed ($150 yeah real cheap) and started finding some parts on Ebay (shaker bubble $145 Bubble vents $100) - My car will use a 4 barrel and I been looking at parts diagrams...