Search results for query: *

Sorry for the long delay. From everybody I spoke with at 3 racing engine shops and 2 dyno shops here in Calif, Johnson was at the top or at least one of the top 2 lifter manufacturers mentioned by all. So I went to Johnson's website under venders, and was not so pleased, so I called Johnson...

I have a complete shaker assembly. My hemi shaker base plate is set up for 2 holly 600, 4 barrel carbs. I believe it's the marine manifold setup with a 8 5/8" center to center spacing. I'm looking for the dual 4 barrel carb base plate piece with the 6 11/16" center to center spacing. Any ideas...

Has anybody used Johnson Hydraulic Roller Lifters? They have two part #'s, 2312BBR and a "reduced seat height lifter" #2311BBR.

I am considering using Johnson Hydraulic Roller Lifters #2311BBR in my current Hemi build. They have a #2312BBR Hyd Roller Lifter, and the #2311BBR with "reduced seat height". But they offer no specs on their website for either lifter. They definitely cost a little more than most other brands...

I don't have a great photo. But, the fuel lines run forward along the inside edge of the rocker, heading to the frame cross member, then make a 90* bend towards the center of the car and another 90* bend forward, thru the frame cross member. It's the only hole there before the Torsion bar hex...

Weld in the Torque boxes first, as they fit better that way. Don't forget to clearance around the spring steel tubing clips so they fit when you need them for your fuel and brake lines. The hardest part about installing the SFC's is trimming them to fit correctly. Patience & more patience is the...

I have replaced both quarters and the deck filler panel using all AMD. And you definitely have to work on some parts more than others. These all fit just fine with a rusted loaner trunk lid. And I was going to final weld them in place. But when I put the original to this car trunk lid back on...

I know AMD has Wheel Lip Moldings.

Thanks for the tips. I used a 1/8" drill where there is only one layer if steel. And a #30 which is slightly larger were there is 2 layers of steel.

Great help on the location of the 2 long glass spacers. There 6 regular clips across the top, 3 clips on each side and 8 clips along the bottom. Plus 2 long spacers. All spaced evenly. You can see there isn't a clip in the corners from the great pictures. But what I don't know is the correct...