Computer placement with vintage air

[junkyard]

Where are you mounting the computer with a vintage air system?

 

[Katfish]

What harness are you using?

 

[pschlosser]

What harness are you using?

I concur the harness limits your mounting options. If not, it is common to mount it behind the front seats, but not in the trunk. There is likely room under the back seat.

 

[junkyard]

My apologies. I'm using the Hotwire wiring harness and a new American auto wiring kit for the lights and such.

 

[Katfish]

Sorry, can't help with that.
I used the MP harness and there was only 1 option without completely redoing it.

Check out reply 172, good pics, whole thread has a lot of good info

A.G.A.R. This just in....THE END ! in Your Restoration project (ROSEVILLE MOPARTS) - Page 12

So actually the wiring worked out well. I very carefully cut into the $2000 harness and removed all the major red feed wire. Because they were all sol

forum.e-bodies.org

 

[hpjunke]

Where are you mounting the computer with a vintage air system?

 

[junkyard]

View attachment 109570

That looks clean. I'm guessing you blocked off the original holes in the firewall where the original A/C hoses went through?

 

[hpjunke]

That looks clean. I'm guessing you blocked off the original holes in the firewall where the original A/C hoses went through?

I did yes my Ac lines come through where the ecu is on top of it .. Tight fit but it works

 

[Buckminster]

That is a pretty clean installation. What transmission are you using? I just picked up a donor vehicle and I like the idea of using the NAG1 transmission. It requires multiple computers between the engine and trans. So space is going to get used up pretty quickly. if you have the same challenge, I was curious where you mounted the other boxes.

 

[hpjunke]

That is a pretty clean installation. What transmission are you using? I just picked up a donor vehicle and I like the idea of using the NAG1 transmission. It requires multiple computers between the engine and trans. So space is going to get used up pretty quickly. if you have the same challenge, I was curious where you mounted the other boxes.

Im using the 545rfe trans so this one computer controls it

 

[JpRngr]

That is a pretty clean installation. What transmission are you using? I just picked up a donor vehicle and I like the idea of using the NAG1 transmission. It requires multiple computers between the engine and trans. So space is going to get used up pretty quickly. if you have the same challenge, I was curious where you mounted the other boxes.

I mounted all 5(?) modules on the passenger inside firewall. Was able to fit them all up there next to the Vintage Air box. May or may not fit if you're using stock hvac box.