Recent content by 3406pk

IIRC When you remove screws that hold top to main body, there is one screw in center that has head on bottom of throttle plate.

Welcome to the site. Nice looking car and you are doing Great.

If you are taking it apart, look at a diagram of carb first. There is a screw in center of carb that is hiding from view (I think head is on bottom of carb). Do not pry top off the plastic bowl. There is a Dodge TSB for Thermoquad that is on the website for Hamtramck Mopar site Section 14...

When you redo electrical, I would recommend bypassing the ammeter. Run a #10 or #8 wire from alternator to battery stud on starter relay. Include a fusible link in the wire too. This is a safety mod to reduce possible fire from bad connection on bulkhead connectors. This is the MAD method...

Thanks for listing ref books. Merry Christmas and Happy Holidays. Gary

Hey Grady. You make me tired just looking at all the work you have done. Great job. The detail work is fantastic. Could you post a list of your reference books and sources please. I noticed several pix from ICCA book that I would like to buy. Thanks a lot.

Super pictures from the past. Great to have those people and memories around.

Hey Grady, the work is looking great. Good job. It seems like you have all original details for correct OEM restore. But if you need any pictures to compare, let me know and I can send.

Thanks Grady for info. I will think about it as I wanted some embroidery put on it.

I want to buy a dash cover for our 70 Cuda to protect dash from sun during carshows. I found several vendors but no pictures of actual cover just generic pictures. Has anybody bought one that fit & could recommend vendor. Thanks

You can adjust the freeplay in the steering gearbox also. That will help with steering wheel play. Sorry didn't see pages 2 & 3 before I posted. Great work on repairing the rust rot also.

There are vin numbers stamped on body in various places, like radiator yoke, rear window/trunk frame, and maybe more. You should research that and find what is required to legally register that car before you sink money into it. If it's a strip only car, you're ok w no title.

If you have 500 lb-ft torque, you should have the 727 TQ built w good clutches and shift package you want. If you keep the 3.23 rear gear, you shouldn't need OD. If you want the OD then get a Keisler Auto w OD (a modified GM trans made to fit mopar engines). I think the Keisler auto will fit...

For a normally aspirated small block, you can have one from column a and one from columm b. By that you can get 500 hp from a 340 with super ported heads and high duration/high lift cam and rev it to 7000-7500 rpm. But that takes good valve train and tuning and maybe race gas. Or put a 4"...

If you can open the hood take a picture of the fender tag that has all the vin info and all the options to see if engine,paint, & options are original. There are vin decoder threads on here and FABO site in forums. Also take a refrigerator magnet to check the lower quarters, front fenders...