Thanks for all the great info! I put in a new 3/8 sending unit with 1/4 return, wrapped the fuel lines with DEI insulation, and am still running both the mechanical fuel pump and the electric kicker pump by the tank that was installed by the shop that put the motor in for me. Drove around this...
I have a 74 challenger that I just swapped a 340 for a stroker 440. The fuel system is original with the exception of a small electric kicker fuel pump run in line by the tank. I am having issues with vapor lock. The car will idle and drive for about 30 minutes on a summer day before cutting...
It is a power master mini starter. The car Did start, ran and drove on city streets (no highway) for about 15 minutes, then Cutoff. When trying to restart, you could hear starter engage but spinning freely, no resistance from the converter. Had the car towed back to trans shop that installed the...
Good afternoon everyone,
I have a 440 stroked to 512 in my 74 challenger mated to a 727 auto. I have had two converters have teeth broken off by the starter. I had a reputable transmission shop install everything and they say that everything was installed properly and that everything lines up...
Looking for Rallye hood in good condition. Does anyone have any leads on where I might be able to find one. All the manufacturers currently have shipping eta’s of last week of May.
Anybody running electric cut outs on their cars? If so, what brand are you running, and are their issues I should look out for? Just swapped a 512 into my Challenger and was thinking of adding them. My concern is exhaust leaks popping up.
Thanks!
Thanks for the info and pics. Beautiful car! I have a tall deck 440 and a taller intake which is causing my clearance issue. The flat hood will close with no air cleaner or air cleaner stud in the carb. I went ahead and ordered the rallye hood to get the extra clearance I needed.
Good morning everyone,
I have a ‘74 challenger that was a factory 318 car with the flat hood, that I am swapping to a 440 based 512 stroker. My questions are:
1. will the 440 fit under the flat hood with carb and air cleaner?
2. Does the bracing on the underside of the R/T hood allow for...