Recent content by CudaGapCuda

Oh do we hear you. Pic Start 2014, Pic Mid 2021, Pic Now 2024/2025 winter

Hey Avalanche Keep in mind that when you have a sure grip rebuilt there are two different shims in the bearing kits the most common that they use has the thicker shims and I went thru two years of a sure grip that was almost a total lockup. After receiving no real good feed back from SixStates...

Oh mine was doing the same thing. I did the same think you did took out and cleaned and lubed then back in and still the same. But then on better inspection I found out that the carpet had a loose piece that was put in because the original carpet shifter hole was cut to large. The guy just cut a...

I need measurment to convert my 71 k-frame into Hemi k-frame for my e-body 426 hemi swap. I would like to find someone out there that could give me the measurment to where to place the hemi weld on brackets for the factory location. Or pehaps someone in or near the Portland Oregon area that has...

Oh, ok thanks and do you have a rough estimation on how long to close. Thanks

How to eliminate a for sale ad or edit when car does not sell

The rust area photos,

1971 Barracuda for sale $45000.00 would like to trade for 1971 Cuda BB, I'm retiring soon and looking for a project car to dissemble clean and restore. More about the Barracuda it has a 340 that is non stock date coded 1971, it is also a factory AC car so all the duck works is still up under the...

Pricing our the Hughes top end kit HUG 2045, I'm looking at $2628.58 plus some miscellaneous cost of $500 to $800, + new 727. I have one last question if I just buy a cam and lifters and use all the parts I have what would your estimates be on HP using the best cam and Lifter to fit the parts I...

MoparCarGuy your information is great , I have a quick last question as I am counting my mopar buck to see what i have to put into this build. Do they make a piston that would be closer to deck height to bring up the compression to say 9.5 to 1 or better that you don't have to worry about the...

Chryco I tried to PM you my number but your inbox is full

Awesome Knowledge Chryco With that information it looks like I need to see how much money I want to put to this build. I was given the engine from a close friend that he was going to put in his 60 Dodge 2 door Seneca but ended up selling the car so I have no money invested yet, hence the...

Chryco, im not sure how to send a private message on this site but if you direct me in how I will sure send you my contact. and a little more information I had sent an e-mail to Oregon cams with the information I show above and received this response back form them. Hydraulic Flat Tappet cams...

Not sure were to put this question for my fellow gear head, I have a 440 that I'm re-assembling that I just took apart it was a complete engine that had everything assembled but someone had removed the cam and lifters. I took it clear to the crank and this is what I have to work with. It should...

Not sure were to put this question for my fellow gear head, I have a 440 that I'm re-assembling that I just took apart it was a complete engine that had everything assembled but someone had removed the cam and lifters. I took it clear to the crank and this is what I have to work with. It should...