Recent content by gtx71

Thank you very much about 11 miles away,

Hello, Looking for a Engine machine shop around Allentown, Pocono Mts. Pa. 440 Cylinder Boring, hot tank, cam bearing installation etc. Any help or recommendations appreciated. Tony B.

Hello, Looking for a Engine machine shop around Allentown, Pocono Mts. Pa. 440 Cylinder Boring, hot tank, cam bearing installation etc. Any help or recommendations appreciated. Tony B.

Hello, Where is a good place to mount a MSD box in a 1974 Dodge Challenger with a 440 and a 833 4 speed

Hello, 1974 Dodge Challenger 440 26'' radiator, with factory A.C. radiator inlet and outlet on passenger side. Can anyone provide me with the correct pt# for the upper and lower radiator hoses. thanks, Tony

Cratos, How did your install of the Bouchillon Performance Engineering a/c kit go, i was thinking of purchasing from them and was just looking for any feedback. Thanks, Tony

John, You have you base timing set for 12 degrees, what is you idle timing set at. Base and idle are 2 different settings. Base is what timing the engine will start at, idle is what it will idle when engine is warm. 12 at base and total advance at 39 is a total timing swing of 27 degrees. i...

Hello, i am looking for the cheapest way to have a spare tire for my 1970 dodge challenger, what 15'' rim with proper back spacing/ bolt circle can i buy from my local bone yard that will work. Tony

Thanks for the help at least i now know that i have 1973 and up water pump housing, The reason i need a pass side inlet is because of my a.c. compressor

How do you like the cold case radiator

Hello, i have 1974 dodge challenger with a 1970 440 big block with functioning a.c. i am looking to upgrade my radiator, the radiator that is in it now, has both the inlet and outlet on passenger side. my water pump inlet in on the passenger also, does anyone have any ideas as to what...