Recent content by Lee W.

Thanks for your help

Have one. do you put it into the cylinder or just out side the spark plug hole ?

Thanks I will try that first

What is the best tool to buy to find top dead center with out tearing the engine apart ? 1972 440

Thanks to everyone for your help I have a car show this weekend. Will get the measurements I need next weekend.

Which shock company was it?

72 cuda 440. ride height from rear bumper to slab 21" same on both sides. 17" rim, 255/45 zr17. pulled bottom of shock, it dropped down about 6" Jacked shock up only went 1" above ride height. looked on summit they have different shocks for Cuda than Barracuda. WHY? MY question is do I need...

new flywheel cleaned shipping oil off with a solvent both flywheel & pressure plate. Ill drive around some if it does not go away ILL BE BACK !

Does that mean the grabby wont ever go away. taking off slow in reverse really shakes the car

I finally got around to changing the clutch, pressure plate & fly wheel. Clutch & pressure is from ACT. Engine is a 440. my new problem now is when I slip the clutch to take off slowly it is real grabby & chatters until full out. is there a brake in procedure to follow or am I in Trouble again?

I asked the question a month ago what can I do with it. no one answered then so to the dump it went

steering box was power but since I had no interest in it I took it to the dump

Well it worked out I did have to cut the shaft 1/2"

That would be great I'll try that out today & see how it fits. thanks!