• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

Recent content by moparmike1974

  1. moparmike1974

    Charcoal canister on 73 challenger 340

    What is wrong with your canister? You can rebuild them. Get some activated charcoal from the pet store (used for aquariums). You will also need a piece of filter material.
  2. moparmike1974

    WTB Cuda quarter window up-stop

    Bump....someone has to have these.
  3. moparmike1974

    WTB WTB A833 Four Speed Mainshaft

    Here are some pictures. Be aware it has cosmoline on it, thats not rust. Length is about 27.5"
  4. moparmike1974

    1971 Cuda front parking light len's - REPRODUCTION

    Likely so. I heard they wanted a small fortune for the rights on them. I was lucky to get some from B&E right at the end before he ran out.
  5. moparmike1974

    WTB WTB A833 Four Speed Mainshaft

    Yeah I will dig it up after work tomorrow (its 2 am here right now). It may be coated in cosmoline for storage....cant remember. It came out of a good trans, swapped the shaft and tail housing to convert it for my swinger.
  6. moparmike1974

    WTB Cuda quarter window up-stop

    Im working on two 74 cudas and only have one of the qtr window upstops. So im looking for three of them. Here is a picture, I only need the piece that screws on the brackets and the hardware if you have it. May be the same on challenger but not sure.
  7. moparmike1974

    WTB WTB A833 Four Speed Mainshaft

    I just converted an E body trans to A body and have a good mainshaft available.
  8. moparmike1974

    Need a measurement on E body ASAP. Radiator to rad support height.

    Thank you for the input, I think I have what I need. Appreciate the help.
  9. moparmike1974

    Need a measurement on E body ASAP. Radiator to rad support height.

    Is that measurment from the top of the filler neck or the tank?
  10. moparmike1974

    Identify 4-speed

    The case appears to be sandblasted but I dont see anything to suspect the numbers were restamped. I have a half dozen four speeds here and the numbers are all over the place like that one.
  11. moparmike1974

    Need a measurement on E body ASAP. Radiator to rad support height.

    Im in the process of custom fitting an aluminum radiator in my 71 cuda. The radiator bolted in fine but needs to be raised up quite a bit to use the factory shroud. So im looking for a measurement from the top of the radiator support to the top of the filler neck. I measured with the factory...
  12. moparmike1974

    Measurements needed

    I responded to your PM. I already cut that jig up since I finished the front of the car.
  13. moparmike1974

    Are E body leaf springs not square?

    I wonder if that affects the handling any. With the USCT spring relocation are they parallel or do they retain the splay in the rear? I have already welded in the front spring buckets and notched the frame rails. Widening the wheel tubs next then will do the rear spring hangers. Im thinking of...
  14. moparmike1974

    Need help with radiator location

    Thanks, that confirms what I though. It appears to stick up above the support. If someone can get me a measurement that would be great.
Back
Top