Recent content by robin93784

thank you both for answering, the instructions show it is needed or it can fry the inside module, it shows the ign wire go's to the resistor and then out to the coil but it shows the red wire that leads to the dist. needs to be before the resistor so if i use the factory resistor on the...

thank you both for the reply, i first posted a electrical question and forgot to leave this section before posting, shows my age! lol

i have a 70 challenger that i put a shaker hood on, the hood wont stay up, it has the big springs on them, i have tried to find new springs but i can only find the small fiberglass hood springs, my question is do you think the springs are bad or worn out hinges, or anyone know where to find...

i have a 70 challenger with a 440, i added a mallory dist. do i need to add a resistor or is the factory resistor on the firewall all i need?

THANK YOU EVERYONE FOR YOUR HELP!!!!

could any body help me to determine how to id a rally dash wire harness from a standard dash harness? i have a couple of harnesses to post for sale and i know one of them is from a rally dash but i want to make sure and list it correctly. thank you!!

if paypal is ok i will take it. thank you paul

sorry! i should read fully first before asking i am showing my age i see the carb is a 600

good morning, how much for the carb and shipping to 32810 and do you know what size it is i need one for my big block thank you!

thank you for all the replies, i went into the frame rail and fit perfect, i felt the tube under the floor pan was a little unstable so i put a small wire loom that fit the tube perfectly on the inside of the frame rail with a small screw to hold it in place and there is no movement at all with...

wtb center ac vent prefer black for 70-74 challenger ac dash, would love to find the center and passenger side

thank you everyone for all your help

thank you for the reply if the small line on the sending unit is for return where do you vent the line once it gos though the floor pan. thanks again

i am looking for the proper venting of my 70 challenger fuel tank, i have the nipple on the filler tube, the tank has been replaced and there are no nipples on the tank, the sender unit has a large nipple and a small nipple i am hoping that the large should be the fuel line to carb and the small...

do you know how much shipping to 32810 thanks again paul